 |
 |
 |
|
#1
07-23-2010, 05:36 PM
|
|||
|
|||
Wheel Spacers to make Jeep Alloys fit an '88?
I bought five 15" Jeep alloys off a 1997 Wrangler with 30x9.5R15 BFG mudders on them. They fit on the back just fine, but I've machined out the center hole on the fronts for the hub and run into another problem; my tie rod end rubs on the inside of the wheel. How thick of a spacer should I put in to fix this problem, and should I do the back ones as well or does it not matter? It looks like it will take quite a bit to kick them out far enough.
__________________
1988 Ford Ranger 2.9L V6, 5 spd. Manual (220,000 Miles) 2" Lift 
|
 |
 |
| Register and never see these ads again. | |
|
|
 |
«
Previous Thread
|
Next Thread
»
| Thread Tools | Search this Thread |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Want to Buy: Wheel spacers!!! | yellow_edge | Engine & Drivetrain Parts | 1 | 07-13-2010 11:31 PM |
| 1/4 inch wheel spacers | RangerRunner | Wheels and Tires | 2 | 05-26-2010 03:44 PM |
| Want to Buy: I'll buy wheel spacers | KickAssRanger | Tire & Wheel Items | 0 | 05-23-2010 09:12 AM |
| wheel spacers | RangerLuc | Wheels and Tires | 13 | 03-01-2010 07:00 PM |
| Wheel spacers!!!!!!!!!! | ec_dago_ryder | Suspension Tech | 16 | 01-25-2010 09:11 PM |
|
|
 |
|
|
 |
 |
 |
