Ford Ranger Forum - Forums for Ford Ranger enthusiasts!

Go Back   Ford Ranger Forum - Forums for Ford Ranger enthusiasts! > >
Forgot Password? Join Us!

Welcome to Ford Ranger Forum

Reply
 
Thread Tools Search this Thread

  #1  
Old 08-29-2019, 08:26 PM
rogerranger2122 rogerranger2122 is offline
Liking the Ford Ranger Forum
 
Join Date: Jul 2016
Posts: 29
Default what why cause dust cover shield rub rotor replace new install? grind squeal noise?

sorry for title, I wanted to put many key words to help anyone else trying to figure this out.

I read many threads people had this happen but no real explanation as to why.
Are new rotors sometimes thicker than OEM? I know break pads don't contact or wear down the outer rim of the rotors where mine is now rubbing, so it's not that but maybe these rotors are like 1/4" thicker than the previous?

I've read threads of people who seem to know a lot about mechanics and installed $500 higher quality rotors and get this problem.

I changed pads and rotors on a 2006 Honda pilot for my sister. About a week later she says there's some sort of leak and bad grinding noise.Turns out the leak was just normal air conditioner drip lol.

I changed pads + rotors like 8 times no problem on various cars, so I didn't want to open up the wheels to check but the thing I noticed that made me open the wheels was the wear indicator tab on the brake pads - I never really gave much thought as to which side of rotor to put that tab but this time I googled and they say to make it so the rotor spins in a way that the tab is ahead of the pad. So as you know the caliper's inside section is the piston and only that piston seats against the back of the inner brake pad. And the outer section of the caliper (towards lug nuts) is sort of a C shape. Well I noticed the C shape side of the caliper (which is where I put the wear indicator) pinches the wear indicator (on some vehicles) because the indicator tab is sometimes secured to the pad in a way that when you install that C side of the caliper only one side of the C is seated against the wear indicator and thus the pad is sort of seated on an angle - so I took the wheels apart to put the wear indicator on the inner side of rotors in case this was causing the noise. As I'm putting it back together I notice the grinding sound that started all this. Then discover it's the rotors rubbing on the dust shield, so I just bent the dust shield back a bit.


But WHY does this happen if not that the new rotors are a bit thicker? When I took the old rotors off, I banged them with a mallet to get them unstuck but even that shouldn't cause the rotor to tilt back and bend the dust cover, and even if it did, the dust cover is bent towards the rotors, not away.
Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search


Similar Threads
Thread Thread Starter Forum Replies Last Post
remove front brake dust shield? ozzypat General Ford Ranger Discussion 7 08-14-2016 06:25 PM
Dust Shield grinding TheArcticWolf1911 Wheels and Tires 3 07-21-2015 02:23 PM
help: how to remove damaged dust shield rfleener1 General Tech 3 01-23-2015 07:42 PM
Want to Buy: 2000 ford front rotor shield for rotors mine rotted out mxpxpunkrock1987 Exterior Parts 0 06-03-2014 10:45 AM
Want to Buy: 2000 ford ranger xlt dust shield for front rotors mxpxpunkrock1987 Exterior Parts 1 05-11-2014 07:00 PM