Where do i find lug nuts for these rims? - Page 2

bear_claw_91 · #16 12-03-2013, 12:49 PM

Quote:

Originally Posted by Logan03CO

No problem - I figured that was the case - those guys can be annoying when it comes to anything not originally issued. Should be good to go with the info: 60 degree acorn/conical setup, closed end, 1/2''-20 RH thread size. Any lugs with that info will get you home!

Thanks a lot

bear_claw_91 · #17 12-10-2013, 11:37 AM

Is there anything wrong with cheap sets? Or should I spend more on a decent brand?

appletonbill · #18 12-10-2013, 12:20 PM

http://www.rockauto.com/catalog/more...202&cc=1431252

Logan03CO · #19 12-10-2013, 12:42 PM

Quote:

Originally Posted by bear_claw_91

Is there anything wrong with cheap sets? Or should I spend more on a decent brand?

Shouldn't be much of an issue if you don't have to keep switching wheels often or anything.

I would assume only the level of finish would/could be different between them.

Quote:

Originally Posted by appletonbill

http://www.rockauto.com/catalog/more...202&cc=1431252

Those seem to be a mag seat...It's been awhile, but I thought the factory lug nuts were the typical acorn seat?

Like I said, a person needs to verify if they need the typical acorn/conical setup or something different (like that mag seat).

bear_claw_91 · #20 12-10-2013, 01:53 PM

Quote:

Originally Posted by Logan03CO

Shouldn't be much of an issue if you don't have to keep switching wheels often or anything. I would assume only the level of finish would/could be different between them. Those seem to be a mag seat...It's been awhile, but I thought the factory lug nuts were the typical acorn seat? Like I said, a person needs to verify if they need the typical acorn/conical setup or something different (like that mag seat).

Ahh ok I didn't even think of the finish. I get my tires rotated every few months so I think I'll pay a little more for a finish that won't look like crap after a few.

And yeah everywhere I've seen says it needs the acorn seat.