 |
 |
 |
|
#1
03-06-2011, 05:26 PM
|
||||
|
||||
New interior mods
I flipped a set of BroncoII seats I had sitting around this past week. I decided to swap my Mustang GT seats for them. recovered in charcoal suede and vinyl. Emblems came from a 64-6 Mustang with the Pony package.
Old:  redone:   man, these seats are so comfy in the truck. when you sit down in them, the bolsters are real firm, and you sink down in the middle. very nice. got to check out how the seat heaters are holding up as well. i had a burnt section in each of the driver's pads. i had a spot that felt like it was getting really hot. now i know why. but being carbon fiber heaters, you can cut them and they still work. so i assume it's the same with burns as they are still working. put them on the passenger side as they don't get as much use there. and now the other piece i worked on. passenger side false panel (airbag cover) Where the graphic came from:  printed and trimmed on the foam:  foam cut out:  wrapped:  
__________________
Krylon Fusion is for Amateurs. 
|
 |
 |
| Register and never see these ads again. | |
|
|
|
|
|
#2
03-06-2011, 05:43 PM
|
||||
|
||||
|
Re: New interior mods
All I can say is "WOW!!!!!" that thing is really coming along, Looks great!!
__________________
So Many Mods,So little Time!! Preformance: SCT Livewire w/ Rogue tunes,Rogue Larger MAF Housing w/ card type sensor,MAC cold air intake,40 series FLOWMASTER exhaust w/ duals,Set of 1.7 Roller rockers,full set of under drive pulley's(Blue),Screamin demon coil,8mm heat braided wires(Blue),double patium plus,Gator back belt,200 amp(power coated blue) Alt.,Taurus fan
|
|
|
|
|
|
#4
03-06-2011, 07:40 PM
|
||||
|
||||
|
Re: New interior mods
damn, thats sweet. good work man!
__________________
1992 Ranger XLT 2.3L 2wd 5spd 91 Mustang rear end, 373 L/S. Quote:
|
|
|
|
|
|
#5
03-06-2011, 07:42 PM
|
||||
|
||||
|
Re: New interior mods
I like both mods!
__________________
2000 2wd Ext cab with explorer 5.0 Mods so far: Explorer ohc and lighted visors, Mustang dome light with LED's, In channel vent visors, Explorer sport trac guages, White faceplate for a/c controls, 8.8 ls rearend with 3:29 gears, 302 swap, coil spacers, 3" body lift, Westin step bars, A.R.E. topper with roof racks, 33x12.50x15 firestone destination a/t's, 8 hole american racing rims. My build thread--> http://www.fordrangerforum.com/proje...ger-build.html
|
|
|
 |
«
Previous Thread
|
Next Thread
»
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Lets talk worst... mods, bad mods, regret mods, not worth the money.... | 2010 | General Ford Ranger Discussion | 93 | 12-07-2011 05:25 PM |
| A Couple New Interior Mods | buggman | Interior Tech | 20 | 06-20-2011 01:22 PM |
| new lights and interior mods | Superlifted06FX4 | Vehicle Snapshots | 3 | 06-20-2011 11:24 AM |
| My interior mods by FRF!!!! | Clinton | Vehicle Snapshots | 36 | 04-14-2011 08:33 PM |
| Almost finished with interior mods | hdmc | Interior Tech | 10 | 01-21-2011 06:04 AM |
|
|
 |
|
|
 |
 |
 |
