hey guys i just picked up some lights from r0ng5 and got them in yeaterday. i had them orininally in the holes in the bumper for the license plate but i was advised that they were kinds useless so low and close together. So today i loves them to where they are this morning. i used the dremel and mounted them where they are now. what you guys think???

__________________

:04 XLT:4.0:4.10 LSD:4x4:2.5" Catback Flowmaster 40 Series Dumped: 3in body lift: AAL in rear: Cranked tbars: 285/75/16 Toyo M/T: Alpine idx100a: Alpine MRP-500: Alpine type R:Exp OHC:

looks good man

__________________
Lifted and junk

Double Lifted Rangers

thank casey... since you liek it oh so much then lets trade ... i love your ride

__________________

:04 XLT:4.0:4.10 LSD:4x4:2.5" Catback Flowmaster 40 Series Dumped: 3in body lift: AAL in rear: Cranked tbars: 285/75/16 Toyo M/T: Alpine idx100a: Alpine MRP-500: Alpine type R:Exp OHC:

maybe tomorrow,

hey what kind of mounting bracket is on the bottom on those lights, do you have a closer pic of the bottom

__________________
Lifted and junk

Double Lifted Rangers

its just drilled into the bottom of the grill.... hold on ill get pics

__________________

:04 XLT:4.0:4.10 LSD:4x4:2.5" Catback Flowmaster 40 Series Dumped: 3in body lift: AAL in rear: Cranked tbars: 285/75/16 Toyo M/T: Alpine idx100a: Alpine MRP-500: Alpine type R:Exp OHC:

that simple

[IMG][/IMG]

__________________

:04 XLT:4.0:4.10 LSD:4x4:2.5" Catback Flowmaster 40 Series Dumped: 3in body lift: AAL in rear: Cranked tbars: 285/75/16 Toyo M/T: Alpine idx100a: Alpine MRP-500: Alpine type R:Exp OHC:

can you tilt them up and down and do you know what part # daylighter that is

I'm guessing 6" slimlight or something like that, I might have to eventually get new lights for my lights up top and I need some that tilt. I made some brackets for my daylighters but I would still need them to tilt farther if I lift the rear anymore

this is what I mean

__________________
Lifted and junk

Double Lifted Rangers

Looks good curt!

Too tall for the garage Casey?

__________________
2001 Ford Ranger Supercab (4dr), Oxford White, 4.0 Sohc, 4x4, Manual trans (hurst equipped), 4:10's, 3" body lift.

yeah I've had to cut 1" out of the spacer then make those brackets so I can fold them down and now I have maybe 1/4" clearance with them folded as far down as I can get.

The flip side is, I am 1" lower in the rear than the front, so if I get new leaf springs to raise the rear up I'm going to be screwed

__________________
Lifted and junk

Double Lifted Rangers

yea they tilt. here is a pic of the bracket. they can tilt forward to a little past parallel to the ground. back not quiet as far.... there are two screws one on each side of the mount to hold it at the right angle. i dont know the part # i bought used. i can look into it tho if you want

__________________

:04 XLT:4.0:4.10 LSD:4x4:2.5" Catback Flowmaster 40 Series Dumped: 3in body lift: AAL in rear: Cranked tbars: 285/75/16 Toyo M/T: Alpine idx100a: Alpine MRP-500: Alpine type R:Exp OHC:

hey casey this looks like what they are. i may be wrong but the mount i have looks like the one on the draWING

http://www.kchilites.com/store/SlimLite-C17.aspx

__________________

:04 XLT:4.0:4.10 LSD:4x4:2.5" Catback Flowmaster 40 Series Dumped: 3in body lift: AAL in rear: Cranked tbars: 285/75/16 Toyo M/T: Alpine idx100a: Alpine MRP-500: Alpine type R:Exp OHC:

cool deal, don't worry about it I can quit being lazy and find them. I wasn't sure if any kc lights came with that type of bracket or not.

Thanks

edit, hell yeah. Those could solve my problems when the time comes, I can get hellas that fold down but I want a 6" round light. I've already kind of crunched one light because it came up a bit while I was driving and didn't notice going into the garage haha

__________________
Lifted and junk

Double Lifted Rangers

LOL well you can still be lazy there you go. look above

__________________

:04 XLT:4.0:4.10 LSD:4x4:2.5" Catback Flowmaster 40 Series Dumped: 3in body lift: AAL in rear: Cranked tbars: 285/75/16 Toyo M/T: Alpine idx100a: Alpine MRP-500: Alpine type R:Exp OHC:

these are 130 watt kc daylighters. they do not make the 130 watts anymore though.

__________________
2004 Ford Ranger EDGE 4x2
3.0L, 4.10 open, 32x11.5x15 BFG A/T KO's [sold]

2010 Ford Mustang GT
4.6 V8. Minor mods

Very nice Curt!

__________________
Sold:2004 XLT 4x2 Ext. Cab. 3.0 Mods: 3" spindle, AAL, shackle, 32x11.5 on 15x8s, billet grille, clear corners, flow 40 dumped, line-x, CB/PA, traction bars, lil sound system, auto up down windows
Sold:2005 XLT 4x4 Ext. Cab. 4.0 Mods: ProComp lights w/ HID swap on tabs, 32x11.5 on 15x8s, CB/PA, black out heads/corners, lil sound system, cranked t-bars, flow 40 dumped, line-x, shell, bed rug, 06+ tails, metal tail gate handle since plastic one shattered, OHC, Mustang Dome.