I think it may be time to part ways with my 93. So I am putting this out as a feeler to get some ideas if anyone would even be interested and if so, what it would even be worth. anyways, here is the info.

93 2wd reg cab short bed (fleetside) xlt. lowered 5" (square beams and progressive rate coils) up front, 4 out back (explorer axle). engine is a 4.0 w/5speed auto behind it, from a 97 ranger, 115k, super chip. as stated before, explorer axle (disk) with 3.55 l/s (may be 3.73, can't recall for sure). rear springs are from a 97 ext cab. 98-00 front clip has been started. have fenders, hood, grill, header panel, and core support. needs lights, bumper, and misc fasteners. core support needs welded in. shaved handles, tails, welded tailgate. interior has an 03 cobra dash and console. dash is mounted, column is mounted. console still needs to be mounted along with door panels fabricated. have power window regulators, just not installed. have the mustang floor shifter as well. sliding rear window.

still needs hvac, the wiring finished (have complete 97 interior/under hood wiring harness to use), exhaust, paint and assembly. the tailgate is starting to crack, so some body work is needed.













again, this is just a feeler. I may even consider parting it out, but not at this time. would rather see it go to someone and finished over being scrapped. feel free to ask questions. have NC title.

__________________
Krylon Fusion is for Amateurs.

ttt

__________________
Krylon Fusion is for Amateurs.

no interest? what about if i parted it out?

__________________
Krylon Fusion is for Amateurs.

I think you should keep it Troy. You put so much into it already, it just needs a few finishing touches

have another baby on the way.....i want to keep it, it's not costing me anything, but i hate to see it just sitting around.

__________________
Krylon Fusion is for Amateurs.

I hear ya man. If the interior was complete I would think about it. I could do the front end myself, I'm just not good at wiring the new dash in