I recently lifted my truck 3 in by suspension and not the front has no travel due to the upper control arms being to close to the frame and I was wanting to know how or if I could fix this
I was thinking longer or differently angled control arms could fix this

__________________
2006 xlt 4×4
6 inch lift

What did your suspension lift consist of?

__________________
Lifted and junk

Double Lifted Rangers

I'm betting torsion keys

__________________
Too much, look at my build thread

^^^

__________________

3 inch torsion keys and buster springs

__________________
2006 xlt 4×4
6 inch lift

That's your problem. IFS suspensions are not made to be raised that high without drop bracketry (aka actual suspension lift). Your best bet it to lower it down about an inch. 2 inches is about as high as you want to go (which stock keys would have done)

__________________
Lifted and junk

Double Lifted Rangers

Would longer a arms not fix that or relocation of the brackets

__________________
2006 xlt 4×4
6 inch lift

No.

__________________
Lifted and junk

Double Lifted Rangers

So turn the torsion down pretty much

__________________
2006 xlt 4×4
6 inch lift

Yes, you can leave it where it is at but you are going to wear out everything up front fairly fast. If you use the truck get good at changing out cv shafts cause they are maxed out and the angles are not good.

__________________
Lifted and junk

Double Lifted Rangers

Ok thanks

__________________
2006 xlt 4×4
6 inch lift