Ford Ranger Forum - Forums for Ford Ranger enthusiasts!

Go Back   Ford Ranger Forum - Forums for Ford Ranger enthusiasts! >
Forgot Password? Join Us!

Welcome to Ford Ranger Forum

Showing results 1 to 25 of 32
Search took 0.00 seconds.
Search: Posts Made By: roscoe 0202
Forum: Electrical Tech 10-13-2018, 11:01 AM
Replies: 12
Views: 181
Posted By roscoe 0202
Re: 04 raner not charging

check alt fuse in fuse box under the hood it is a 15 amp
roscoe
Forum: 4-Cylinder Tech 10-03-2018, 10:24 AM
Replies: 5
Views: 232
Posted By roscoe 0202
Re: Oil pressure drop.

sounds like the pickup is clear from no suction when turned off for awhile then when started the whatever is sucked onto the screen blocking flow if you have oil pressure when first started I would...
Forum: 4.0 SOHC / 4.0 OHV Tech 09-30-2018, 11:36 AM
Replies: 20
Views: 517
Posted By roscoe 0202
Re: which engine oil?

i'm an amsoil fan
roscoe
Forum: Drivetrain Tech 09-23-2018, 12:52 PM
Replies: 3
Views: 169
Posted By roscoe 0202
Re: Stuck in 4 low.

try backing up 10 or 15 feet then try shifting remember if it is electric shift that brake pedal has to be applied and trans in neutral or park
roscoe
Forum: General Ford Ranger Discussion 09-23-2018, 12:48 PM
Replies: 5
Views: 275
Posted By roscoe 0202
Re: 2019 ranger on a car chassis?

they don't want to wait to sell you a new vehicle wait for the ranger and buy it from someone else
roscoe
Forum: 4.0 SOHC / 4.0 OHV Tech 09-21-2018, 11:20 AM
Replies: 2
Views: 205
Posted By roscoe 0202
Re: Swap 96 4.0 into 94 4.0

make the new engine look like the older engine and swap the sensors the old was obd-1 new is obd-2 if you change everything over it should be just fine
roscoe
Forum: Drivetrain Tech 09-10-2018, 10:29 AM
Replies: 3
Views: 206
Posted By roscoe 0202
Re: Auto Tran compatubility

check around and see if you can get a stand alone controller for the new trans check mustang forums
roscoe
Forum: Electrical Tech 09-08-2018, 11:28 AM
Replies: 21
Views: 537
Posted By roscoe 0202
Re: Electrical problems with starter

check the solenoid on the starter and the 14 guage wire running to it
roscoe
Forum: Drivetrain Tech 08-22-2018, 10:01 AM
Replies: 8
Views: 386
Posted By roscoe 0202
Re: M5OD-R1 or M5OD-R1-HD

the hd has one bolt on passenger side that is out of line from the one on the other side it is the middle one this is to miss the camshaft drive
roscoe
Forum: 4-Cylinder Tech 08-09-2018, 12:23 PM
Replies: 16
Views: 784
Posted By roscoe 0202
Re: Thermostat dropping temp randomly?

if it ain't broke don't fix it

roscoe
Forum: General Tech 07-30-2018, 10:24 AM
Replies: 11
Views: 720
Posted By roscoe 0202
Re: Oil and Type A/C Compressor 1992 Ranger

there's a plug in the side of the compressor add the oil there
roscoe
ps the oil in the accumulator goes in the outlet
Forum: 4.0 SOHC / 4.0 OHV Tech 07-25-2018, 10:27 AM
Replies: 3
Views: 504
Posted By roscoe 0202
Re: Misplaced Plug

looks like an injector plug to me

roscoe
Forum: General Tech 07-20-2018, 10:24 AM
Replies: 11
Views: 720
Posted By roscoe 0202
Re: Oil and Type A/C Compressor 1992 Ranger

I have a 92 explorer manual it says 10 ounces of oil 7 in compressor and three in the receiver dryer
roscoe
Forum: How-To Submissions 07-15-2018, 11:21 AM
Replies: 3
Views: 614
Posted By roscoe 0202
Re: Alt. Options to fix fuel line.

go to rock auto they show some fuel line fixes
roscoe
Forum: Drivetrain Tech 07-13-2018, 11:54 AM
Replies: 4
Views: 555
Posted By roscoe 0202
Re: Need help with inpropper drive axle / ujoint removal install

you have to phase the u-joints and slip yoke if you pulled it apart
roscoe
Forum: 3.0 Vulcan Tech 07-09-2018, 10:59 AM
Replies: 5
Views: 891
Posted By roscoe 0202
Re: Coolant Inquiry ?

check the hoses
roscoe
Forum: 3.0 Vulcan Tech 07-09-2018, 10:55 AM
Replies: 12
Views: 814
Posted By roscoe 0202
Re: Oil gauge?

ground the wire to the sender if the guage does not go to high the guage or wire are at fault
roscoe
Forum: 4.0 SOHC / 4.0 OHV Tech 06-25-2018, 10:18 AM
Replies: 2
Views: 610
Posted By roscoe 0202
Re: 98 4.0 ohv replacing 94 4.0

take all of the sensors from the 94 and install them on the 98 engine any that are not on the 94 you won't need
roscoe
ps just set two engines side by side and make the 98 look like the 94 did
Forum: 4.0 SOHC / 4.0 OHV Tech 05-23-2018, 01:52 PM
Replies: 6
Views: 794
Posted By roscoe 0202
Re: Hard to start 1991 4.0L

have you looked at the pressure regulator
roscoe
Forum: 4.0 SOHC / 4.0 OHV Tech 05-16-2018, 01:48 PM
Replies: 11
Views: 858
Posted By roscoe 0202
Re: Speed tops out at 90 miles per hour

you can get a chip that will remove speed installed by ford.
roscoe
Forum: General Ford Ranger Discussion 05-13-2018, 10:36 AM
Replies: 8
Views: 614
Posted By roscoe 0202
Re: Tow behind rv

go to ford I think they still have a kit to put your transfer case in neutral for towing
roscoe
Forum: 4-Cylinder Tech 04-29-2018, 12:21 PM
Replies: 11
Views: 993
Posted By roscoe 0202
Re: Quick Help Needed....What's gone wrong??

by the way the rear wheel bearings in the 8.8 diff are not sealed they are open and the axle is the inner race.
check those by the heat in the hubs also feel front hubs to see if one of those is hot...
Forum: General Tech 04-28-2018, 11:11 AM
Replies: 3
Views: 798
Posted By roscoe 0202
Re: Brake Proportioning valve... do I really need it?

you can get a proportioning valve for early bronco will have to be engineered in but from bronco graveyard about 75.00
roscoe
Forum: 2.9 Liter Tech 04-18-2018, 06:52 PM
Replies: 1
Views: 862
Posted By roscoe 0202
Re: temp gauge not working

the one wire sender by the thermostst is the guage sender ground that wire if the guage goes to max temp it is the sender if it does not move it is the wiring or the guage.
roscoe
Forum: Electrical Tech 04-18-2018, 06:47 PM
Replies: 3
Views: 552
Posted By roscoe 0202
Re: Difference between 95A & the 130A alternator.

all the people that I know who have researched it say this is so.two holes big amps 4 holes low amp
roscoe
Showing results 1 to 25 of 32