Ford Ranger Forum - Forums for Ford Ranger enthusiasts!

Go Back   Ford Ranger Forum - Forums for Ford Ranger enthusiasts! >
Forgot Password? Join Us!

Welcome to Ford Ranger Forum

Showing results 1 to 25 of 237
Search took 0.01 seconds.
Search: Posts Made By: TxGasRacer
Forum: General Ford Ranger Discussion 12-28-2018, 11:43 AM
Replies: 4
Views: 247
Posted By TxGasRacer
Re: What is this?

Driveshaft damper
Forum: 4.0 SOHC / 4.0 OHV Tech 12-06-2018, 12:31 PM
Replies: 12
Views: 444
Posted By TxGasRacer
Re: 2004 ranger 4.0 sohc. cranks/ no start

http://visualbits.net/Car%20Stuff/Ford%20Ranger%202001-2008/
Forum: 4.0 SOHC / 4.0 OHV Tech 12-05-2018, 07:07 AM
Replies: 4
Views: 336
Posted By TxGasRacer
Re: thermostat sensors?

The two temp sensors are Not the same one is a one-wire temp sensor and the other is a two-wire temp sensor. the one wire sensor is for engine temp to the temp gauge and the two wire sensor is for...
Forum: Electrical Tech 11-13-2018, 10:51 AM
Replies: 7
Views: 352
Posted By TxGasRacer
Re: Fuel pump not turning on

visualbits.net/Car%20Stuff/Ford%20Ranger%202001-2008/2005%20WIRING.pdf

visualbits.net/Car%20Stuff/Ford%20Ranger%202001-2008/
Forum: 4.0 SOHC / 4.0 OHV Tech 11-09-2018, 08:14 PM
Replies: 2
Views: 439
Posted By TxGasRacer
Re: c 1095 code

https://www.yourmechanic.com/article/c1095-obd-ii-trouble-code-abs-hydraulic-pump-motor-circuit-failure-by-parker-hill
Forum: 3.0 Vulcan Tech 11-08-2018, 12:44 PM
Replies: 6
Views: 391
Posted By TxGasRacer
Re: No start

Pull the bed off it is easier than pulling your fuel tank from under the truck. There are like six bolts in the bed and then three screws that hold the filler neck to the bedside and then you can...
Forum: Introduce Yourself 10-11-2018, 05:16 PM
Replies: 6
Views: 359
Posted By TxGasRacer
Re: I am female. Need i say more?

Welcome from SouthEast Texas
Forum: 4.0 SOHC / 4.0 OHV Tech 07-07-2018, 06:54 AM
Replies: 4
Views: 1,044
Posted By TxGasRacer
Re: 98 ranger 4.0 lean in both banks puzzled

It is more than likely your upper intake o-ring gaskets. I have a 1998 4.0 super cab and I had this happen to me,after I changed out the upper intake o-ring gaskets my lean trouble codes p0171 and...
Forum: 4.0 SOHC / 4.0 OHV Tech 08-29-2017, 11:44 AM
Replies: 2
Views: 1,200
Posted By TxGasRacer
Re: P0174

http://www.fordrangerforum.com/4-0-sohc-4-0-ohv-tech/15560-01-4-0-lean-codes-po171-po174-look.html
Forum: General Ford Ranger Discussion 08-19-2017, 03:08 PM
Replies: 12
Views: 759
Posted By TxGasRacer
Re: front main seal

Unbolt it from the flexplate but leave it on the trans shaft so you dont make a mess with trans fluid
Forum: 4.0 SOHC / 4.0 OHV Tech 06-20-2017, 11:11 AM
Replies: 40
Views: 2,676
Posted By TxGasRacer
Forum: General Tech 03-19-2017, 09:26 AM
Replies: 1
Views: 502
Posted By TxGasRacer
Re: Throttle position sensor issues

The reving up and then back down is more than likely going to be your Idle Air Control Valve and you will either have to clean yours out OR buy a new one and replace your old one.
Forum: Electrical Tech 11-17-2016, 06:30 AM
Replies: 1
Views: 508
Posted By TxGasRacer
Re: Truck wont start

http://troubleshootmyvehicle.com/ford/4.0L/how-to-test-a-no-start-condition-1
Forum: General Tech 09-13-2016, 07:00 AM
Replies: 3
Views: 575
Posted By TxGasRacer
Re: Crank/No Start 93 XLT

The link is for the 2.3 ltr and good luck.
Forum: General Tech 09-12-2016, 11:50 PM
Replies: 3
Views: 575
Posted By TxGasRacer
Re: Crank/No Start 93 XLT

http://easyautodiagnostics.com/ford/2.3L/icm-and-crank-sensor-tests-1
Forum: 4.0 SOHC / 4.0 OHV Tech 08-31-2016, 11:15 AM
Replies: 32
Views: 2,660
Posted By TxGasRacer
Re: P0174 Lean Condition Bank 2 - getting desperate

Look through the second link I posted it gives a step by step procedure to identify problems. ...
Forum: 4.0 SOHC / 4.0 OHV Tech 08-31-2016, 08:39 AM
Replies: 32
Views: 2,660
Posted By TxGasRacer
Re: P0174 Lean Condition Bank 2 - getting desperate

http://www.fordrangerforum.com/4-0-sohc-4-0-ohv-tech/15560-01-4-0-lean-codes-po171-po174-look.html ...
Forum: 4.0 SOHC / 4.0 OHV Tech 08-24-2016, 09:12 AM
Replies: 2
Views: 597
Posted By TxGasRacer
Re: Help locating the vacuum reservoir.

take down your passenger side inner fender well and the vaccum reservoir ball will be mounted to the lower area of the inner fender well close to the fire wall,but you can not see it untill you drop...
Forum: 4.0 SOHC / 4.0 OHV Tech 08-11-2016, 07:03 AM
Replies: 3
Views: 772
Posted By TxGasRacer
Re: 99 Ford Ranger ABS codes and brae problem

C1230 Rear Axle Wheel Speed Sensor Input Circuit
Failure
Note: DTC...
Forum: 4.0 SOHC / 4.0 OHV Tech 08-05-2016, 07:38 AM
Replies: 9
Views: 1,168
Posted By TxGasRacer
Re: External Head gasket Leak

Inlet Air Temp Sensor
Forum: 4.0 SOHC / 4.0 OHV Tech 07-20-2016, 11:37 AM
Replies: 5
Views: 1,120
Posted By TxGasRacer
Re: 2000 Ranger P0133 P0153 Drive into lake and report stolen?

http://troubleshootmyvehicle.com/ford/4.0L/troubleshooting-P0171-and-P0174-page-1
Forum: 4-Cylinder Tech 07-19-2016, 09:10 PM
Replies: 9
Views: 1,126
Posted By TxGasRacer
Re: p0171 lean code won't go away

http://troubleshootmyvehicle.com/ford/4.0L/troubleshooting-P0171-and-P0174-page-1
Forum: General Tech 06-18-2016, 09:10 AM
Replies: 2
Views: 497
Posted By TxGasRacer
Re: Truck won't start while hot

http://troubleshootmyvehicle.com/ford/4.0L/how-to-test-the-alternator-1 http://troubleshootmyvehicle.com/ford/4.0L/how-to-test-the-starter-motor-1 ...
Forum: 3.0 Vulcan Tech 06-17-2016, 03:30 PM
Replies: 1
Views: 619
Posted By TxGasRacer
Re: crank no start

http://troubleshootmyvehicle.com/ford/4.0L/how-to-test-a-no-start-condition-1
Forum: General Tech 05-25-2016, 08:55 AM
Replies: 1
Views: 588
Posted By TxGasRacer
Re: How do I remove and replace the windshield fluid jets?

There is a small metal bracket under the hood that needs to be removed to take the washer jets out from below the hood.
Showing results 1 to 25 of 237