Ford Ranger Forum - Forums for Ford Ranger enthusiasts!

Go Back   Ford Ranger Forum - Forums for Ford Ranger enthusiasts! >
Forgot Password? Join Us!

Welcome to Ford Ranger Forum

Showing results 1 to 19 of 19
Search took 0.00 seconds.
Search: Posts Made By: roscoe 0202
Forum: How-To Submissions 07-15-2018, 11:21 AM
Replies: 3
Views: 203
Posted By roscoe 0202
Re: Alt. Options to fix fuel line.

go to rock auto they show some fuel line fixes
roscoe
Forum: Drivetrain Tech 07-13-2018, 11:54 AM
Replies: 4
Views: 270
Posted By roscoe 0202
Re: Need help with inpropper drive axle / ujoint removal install

you have to phase the u-joints and slip yoke if you pulled it apart
roscoe
Forum: 3.0 Vulcan Tech 07-09-2018, 10:59 AM
Replies: 5
Views: 448
Posted By roscoe 0202
Re: Coolant Inquiry ?

check the hoses
roscoe
Forum: 3.0 Vulcan Tech 07-09-2018, 10:55 AM
Replies: 12
Views: 382
Posted By roscoe 0202
Re: Oil gauge?

ground the wire to the sender if the guage does not go to high the guage or wire are at fault
roscoe
Forum: 4.0 SOHC / 4.0 OHV Tech 06-25-2018, 10:18 AM
Replies: 2
Views: 246
Posted By roscoe 0202
Re: 98 4.0 ohv replacing 94 4.0

take all of the sensors from the 94 and install them on the 98 engine any that are not on the 94 you won't need
roscoe
ps just set two engines side by side and make the 98 look like the 94 did
Forum: 4.0 SOHC / 4.0 OHV Tech 05-23-2018, 01:52 PM
Replies: 6
Views: 495
Posted By roscoe 0202
Re: Hard to start 1991 4.0L

have you looked at the pressure regulator
roscoe
Forum: 4.0 SOHC / 4.0 OHV Tech 05-16-2018, 01:48 PM
Replies: 11
Views: 637
Posted By roscoe 0202
Re: Speed tops out at 90 miles per hour

you can get a chip that will remove speed installed by ford.
roscoe
Forum: General Ford Ranger Discussion 05-13-2018, 10:36 AM
Replies: 8
Views: 546
Posted By roscoe 0202
Re: Tow behind rv

go to ford I think they still have a kit to put your transfer case in neutral for towing
roscoe
Forum: 4-Cylinder Tech 04-29-2018, 12:21 PM
Replies: 11
Views: 715
Posted By roscoe 0202
Re: Quick Help Needed....What's gone wrong??

by the way the rear wheel bearings in the 8.8 diff are not sealed they are open and the axle is the inner race.
check those by the heat in the hubs also feel front hubs to see if one of those is hot...
Forum: General Tech 04-28-2018, 11:11 AM
Replies: 3
Views: 549
Posted By roscoe 0202
Re: Brake Proportioning valve... do I really need it?

you can get a proportioning valve for early bronco will have to be engineered in but from bronco graveyard about 75.00
roscoe
Forum: 2.9 Liter Tech 04-18-2018, 06:52 PM
Replies: 1
Views: 519
Posted By roscoe 0202
Re: temp gauge not working

the one wire sender by the thermostst is the guage sender ground that wire if the guage goes to max temp it is the sender if it does not move it is the wiring or the guage.
roscoe
Forum: Electrical Tech 04-18-2018, 06:47 PM
Replies: 3
Views: 457
Posted By roscoe 0202
Re: Difference between 95A & the 130A alternator.

all the people that I know who have researched it say this is so.two holes big amps 4 holes low amp
roscoe
Forum: 2.9 Liter Tech 04-17-2018, 11:02 AM
Replies: 2
Views: 343
Posted By roscoe 0202
Re: 1990 Ranger XLT 2.9L

all 2.9 heads were cast iron.
roscoe
Forum: 2.9 Liter Tech 04-04-2018, 04:20 PM
Replies: 1
Views: 404
Posted By roscoe 0202
Re: Electrical connector

white black goes from alt to volt regulator brown pink ignition switch to starter relay little post this is start orange blue alternator to regulator red yellow hash used in carbureted app don't know...
Forum: 4.0 SOHC / 4.0 OHV Tech 03-23-2018, 06:22 PM
Replies: 2
Views: 989
Posted By roscoe 0202
Re: 1991 Fuel Lines

I used russels 632073 103111 103110 611273 611203 610095 with 86243 carcraft filter this was bought from jegs or summit I can't remember replaced from tank to fuel hoses on engine
roscoe
Forum: 3.0 Vulcan Tech 03-19-2018, 07:48 PM
Replies: 1
Views: 543
Posted By roscoe 0202
Re: Need motor help

91 is for sure interchangeable but I think with changing out egr 9-94 should interchange all ohv would but you would want to change sensors to 91-92
roscoe
Forum: Fabrication and Tool Tech 03-18-2018, 07:45 PM
Replies: 16
Views: 3,017
Posted By roscoe 0202
Re: Toolbox suggestions/info

check the pawn shops I bought snap-on for 1700.00with that many tools in it.
roscoe
Forum: General Tech 03-14-2018, 08:08 PM
Replies: 4
Views: 592
Posted By roscoe 0202
Re: Brake Help!!!

check the runout on the rotors to see if they are warped.
roscoe
Forum: Introduce Yourself 03-01-2018, 02:59 PM
Replies: 1
Views: 213
Posted By roscoe 0202
newb

hi i'm roscoe I live in salt lake city ut
I have a 94 stock b4000 mazda got it a year ago after looking for a ranger for about two years it is totally stock with 123xxx miles on the clock
I know it...
Showing results 1 to 19 of 19