Ford Ranger Forum - Forums for Ford Ranger enthusiasts!

Go Back   Ford Ranger Forum - Forums for Ford Ranger enthusiasts! >
Forgot Password? Join Us!

Welcome to Ford Ranger Forum

Showing results 1 to 25 of 57
Search took 0.03 seconds.
Search: Posts Made By: Richard_Crainium
Forum: 4-Cylinder Tech 10-19-2012, 01:50 PM
Replies: 12
Views: 4,266
Posted By Richard_Crainium
Re: Pilot bearing replacement/substitute

dude lifetime war is cool... FOR BRAKES go to the ford dealer for anything to do with alot of work. My ford clutch lasted 185k and the cheep az one lasted 60 it was replace with moto the second time...
Forum: 4-Cylinder Tech 10-19-2012, 01:47 PM
Replies: 28
Views: 2,632
Posted By Richard_Crainium
Re: No Power 5mpg! Im Desperate

to pull codes from obd1. there is a single wire and a plug with a bunch... ignore the one with a bunch and jump the single to the neg bat terminal. then hop in the truck and turn the key to the run...
Forum: 4-Cylinder Tech 10-17-2012, 01:29 PM
Replies: 11
Views: 7,712
Posted By Richard_Crainium
Re: Idle Air Control Valve

ONLY USE MAF CLEANER ON MAF. ok to use carb cleaner on iac but not maf
Forum: 4-Cylinder Tech 10-16-2012, 04:15 PM
Replies: 11
Views: 1,704
Posted By Richard_Crainium
Re: Clicking under Load

spenc Your front u-joint is bad you should go ahead and do both they're cheap enough and its not worth dropping the drive shaft for one.
Forum: 4-Cylinder Tech 10-16-2012, 04:04 PM
Replies: 11
Views: 2,136
Posted By Richard_Crainium
Re: doesn't want to idle.

should be on the firewall side of the throttle body. next to the egr
Forum: 4-Cylinder Tech 10-16-2012, 04:01 PM
Replies: 3
Views: 986
Posted By Richard_Crainium
Forum: 4-Cylinder Tech 10-16-2012, 02:53 PM
Replies: 7
Views: 744
Posted By Richard_Crainium
Re: Need help

94 and 95 same motor bro
Forum: 4-Cylinder Tech 10-16-2012, 02:51 PM
Replies: 6
Views: 763
Posted By Richard_Crainium
Re: 93 ford ranger stating issues! Need advice

If gas is coming out of the presure reg vac line then the diaphram shot and you need a new one. not saying is good if its not leaking just sayin if it is its shot
Forum: 4-Cylinder Tech 10-15-2012, 05:05 PM
Replies: 48
Views: 15,641
Posted By Richard_Crainium
Re: 1999 Ranger New clutch, not able to shift gears still?

not sure if a 99 is the same as my 94 but if you have a air bubble in the master you wont have a clutch and the only way to get it out is to remove the master from firewall and bleed manually or use...
Forum: Interior Tech 10-15-2012, 03:46 PM
Replies: 19
Views: 3,006
Posted By Richard_Crainium
Re: Switches that will fit in my cigarette lighter hole

dude you will miss your cig lighter when your phone is dead and your stuck on the side of the road. shouldnt be hard to figure out you have a hot wire and a ground...
Forum: Drivetrain Tech 10-15-2012, 03:43 PM
Replies: 4
Views: 1,076
Posted By Richard_Crainium
Re: transmission scraping while moving. HELP!

not much diff. other then dicontecting the fluid line... its a pain to bleed the system pray you dont have to bleed the system bro
Forum: General Ford Ranger Discussion 10-15-2012, 03:37 PM
Replies: 22
Views: 2,673
Posted By Richard_Crainium
Re: Had to share this

yeah mines down at the moment.... and I bought it with 232k for 400 bucks off a buddy. I did tuneup breaks and drove it to 300k then put a trany and clutch kit in it cuz i was tired of skipping 4th...
Forum: Lifted Suspension 10-15-2012, 03:29 PM
Replies: 8
Views: 2,518
Posted By Richard_Crainium
Forum: Off Topic 10-13-2012, 10:50 PM
Replies: 22
Views: 2,244
Posted By Richard_Crainium
Re: Welding.

its a little lincin 110 buzz box with a gas kit on it and a lincin 220v stick. I use the buzzer for body and stick for frame I got the buzz at home depot for 320 plus 100 for the gas kit and i got...
Forum: 4-Cylinder Tech 10-12-2012, 06:17 PM
Replies: 3
Views: 1,209
Posted By Richard_Crainium
Re: Near stall idle

clean out your iac valve
Forum: 4-Cylinder Tech 10-12-2012, 06:12 PM
Replies: 6
Views: 1,533
Posted By Richard_Crainium
Re: 1984 ranger 2.0 running question

the choke controls the amount of fuel air mixture in the carb. If its not functioning properly then there will be too much air not enough fuel vapor to start the truck the choke should be closed when...
Forum: 4-Cylinder Tech 10-12-2012, 06:03 PM
Replies: 5
Views: 1,101
Posted By Richard_Crainium
Forum: 4-Cylinder Tech 10-12-2012, 06:00 PM
Replies: 5
Views: 665
Posted By Richard_Crainium
Re: Help

thx Im thinkn egr.... the cat hasnt been there for 2 years so im pritty sure that is not the problem
Forum: Lifted Suspension 10-12-2012, 05:36 PM
Replies: 8
Views: 2,518
Posted By Richard_Crainium
Re: 93 2wd Camber problem with new coils (adjustable bushings didn't solve it)

they make shims to adjust the camber. Not sure how they are installed they fixd mine at the shop included in the alignment. they charged me like 35 bucks for the shims and install.
Forum: 4-Cylinder Tech 10-12-2012, 05:27 PM
Replies: 24
Views: 2,690
Posted By Richard_Crainium
Re: run away truck

there is seals inside the mater cyly and if they go bad when you press the breaks the fluid will go from one side of the piston to the other side of the piston and not pushed through the break lines...
Forum: 4-Cylinder Tech 10-12-2012, 04:43 PM
Replies: 3
Views: 812
Posted By Richard_Crainium
Re: 94 2.3L 5speed running like ish

I think i may have found the issue... the vac line that goes to the dpf sensor on the firewall fell apart when I touched them... What should they be replaced with... reg vac line i would think that...
Forum: 4-Cylinder Tech 10-12-2012, 03:46 PM
Replies: 3
Views: 812
Posted By Richard_Crainium
Re: 94 2.3L 5speed running like ish

iac is less the 6 months Ill start with egr. thanks
Forum: Off Topic 10-12-2012, 03:42 PM
Replies: 22
Views: 2,244
Posted By Richard_Crainium
Re: Welding.

this is my job bro... what do you plan on welding is what decides what to you want to use... what you have decides what you will use. I have a mig and stick at the house... working on my 57 chevy...
Forum: General Ford Ranger Discussion 10-12-2012, 03:39 PM
Replies: 13
Views: 1,036
Posted By Richard_Crainium
Re: Out for 6 weeks

[QUOTE=Spidey2011;1051517]What kind of person would wax another man's truck?

ahhh a detail shop
Forum: 4-Cylinder Tech 10-12-2012, 03:35 PM
Replies: 3
Views: 812
Posted By Richard_Crainium
94 2.3L 5speed running like ish

Ok been messn with my ranger for a week and a half and having trouble figuring out what is wrong. pulling codes 998 and 224. the truck idles great but has no power and acts like its out of time....
Showing results 1 to 25 of 57