Ford Ranger Forum - Forums for Ford Ranger enthusiasts! > Search Forums Search Results

User Name Remember Me? Password Forgot Password? Join Us!

Welcome to Ford Ranger Forum

Showing results 1 to 10 of 10 Search took 0.03 seconds. Search: Posts Made By: eshock

Forum: Electrical Tech 12-09-2019, 05:24 AM

Replies: 0 Lights not working after fender bender Views: 859 Posted By eshock Lights not working after fender bender Had a parking lot accident last week and my rear bumper was yanked out pretty bad on the driver's side. In the accident, the wires going to the license plate light on the driver's side were pinched...

Forum: 3.0 Vulcan Tech 10-25-2018, 04:15 AM

Replies: 2 Oil pressure issue Views: 1,139 Posted By eshock Oil pressure issue My '03 Ranger has 148k on the odometer. The past few mornings, after driving for about 10 minutes, my oil pressure gauge will flutter and drop to zero. It will jump back up to good, especially if I...

Forum: Drivetrain Tech 08-01-2013, 04:29 PM

Replies: 4 Trying to diagnose rear-end issues: bearing, driveshaft, or other Views: 1,835 Posted By eshock I'd like to express my thanks to those who... I'd like to express my thanks to those who responded. I did the job today, and - as you can see from the picture - there is no doubt in mind that the U-Joint was bad. I chose not to do anything...

Forum: Drivetrain Tech 07-29-2013, 11:09 AM

Replies: 4 Trying to diagnose rear-end issues: bearing, driveshaft, or other Views: 1,835 Posted By eshock Re: Trying to diagnose rear-end issues: bearing, driveshaft, or other Just got done checking the U-joints, and there is just a touch of play on the rear. Since there shouldn't be any play at all, looks like this may be the culprit. The front had zero play, but I...

Forum: Drivetrain Tech 07-28-2013, 09:41 AM

Replies: 4 Trying to diagnose rear-end issues: bearing, driveshaft, or other Views: 1,835 Posted By eshock Trying to diagnose rear-end issues: bearing, driveshaft, or other I've got a 2003 Ranger Edge with the 3.0 (not the flex-fuel), automatic trans and 116,000 on the odometer. A few months ago, I developed some noise in the rear end. This started with some noise...

Forum: Interior Tech 04-18-2010, 12:53 PM

Replies: 1 Replacing instrument cluster lights - Thanks and addendum Views: 1,881 Posted By eshock Replacing instrument cluster lights - Thanks and addendum Hey, all! I just want to say thank you to this forum for the very detaild, step-by-step gude for replacing the instrument cluster lights: ...

Forum: Interior Tech 03-27-2010, 07:46 AM

Replies: 4 Need instrument panel help Views: 2,107 Posted By eshock Need instrument panel help I'm having two issues with my instrument panel that I will be needing to fix at some point. However, I am needing guidance as to the scope of the work. My Ranger is an '03 3.0L engine, Edge...

Forum: General Ford Ranger Discussion 01-09-2010, 08:03 PM

Replies: 29 Oil Filters Views: 4,566 Posted By eshock I've used Fram filters for years, but a couple of... I've used Fram filters for years, but a couple of months ago, I developed an oil leak. Turned out that the filter's rubber gasket was leaking. Changed the filter and oil and the leak stopped, and...

Forum: 3.0 Vulcan Tech 01-09-2010, 06:23 PM

Replies: 2 Likely culprit??? Views: 970 Posted By eshock I shot some WD40 on the idler, and sure enough,... I shot some WD40 on the idler, and sure enough, the squealing immediatley stopped. However, since this means there is a bearing that's bad, I'm going to go ahead and replace the pulley. My next...

Forum: 3.0 Vulcan Tech 01-09-2010, 01:43 PM

Replies: 2 Likely culprit??? Views: 970 Posted By eshock Likely culprit??? My 2003 Ranger Edge (3.0L engine), with 92k miles on it (as I write this) started "singing" recently in that typical sign that the serpentine belt was nearing the end of its life. So, I replaced the...

Showing results 1 to 10 of 10