Ford Ranger Forum - Forums for Ford Ranger enthusiasts!

Go Back   Ford Ranger Forum - Forums for Ford Ranger enthusiasts! >
Reload this Page Search Results
Forgot Password? Join Us!
FRF Store Register Ranger Pictures Community Today's Posts Search

Welcome to Ford Ranger Forum

Showing results 1 to 24 of 24
Search took 0.04 seconds. Search: Posts Made By: ZohanisBack
Forum: 4-Cylinder Tech 11-14-2012, 07:19 PM
Replies: 5
Views: 896
Posted By ZohanisBack
Re: Clutch Question and WARNING ON EBAY CLUTCHES

Just did... Not worried about the slave, just the clutch. Hoping I can split the trans enough without disconnecting hydraulic lines. Is it possible?
Forum: 4-Cylinder Tech 11-14-2012, 07:12 PM
Replies: 5
Views: 896
Posted By ZohanisBack
Clutch Question and WARNING ON EBAY CLUTCHES

First up: Do I have to disconnect the hydraulic line if I just want to move the transmission back 4-6 inches and replace just the clutch? There's the question, and now the warning:

So... I went...
Forum: 4-Cylinder Tech 06-13-2012, 10:27 PM
Replies: 3
Views: 3,107
Posted By ZohanisBack
Re: Low Oil Pressure At End Of Oil Life?

I have a a 1994 Ranger 2.3L... And I actually thought about this because I knew some Fords have dummy gauges... And I gotta say, that's the stupidest thing I have ever heard. There's a reason Ford...
Forum: 4-Cylinder Tech 06-12-2012, 09:52 PM
Replies: 35
Views: 16,025
Posted By ZohanisBack
Re: Valve or lifter tick

Ugg, you're right.... Well....could be not enough oil... Have you checked for adequate oil pressure at the valve train? Or a lash adjuster has failed... The latter being the cheaper fix compared...
Forum: 4-Cylinder Tech 06-12-2012, 09:45 PM
Replies: 35
Views: 16,025
Posted By ZohanisBack
Re: Valve or lifter tick

Have you checked your clearances yet?
Forum: 4-Cylinder Tech 06-12-2012, 09:12 PM
Replies: 3
Views: 3,107
Posted By ZohanisBack
Low Oil Pressure At End Of Oil Life?

Hi guys. I have low oil pressure consistently at the end of every oil life (and sometimes in between). It goes from consistently halfway in between the normal zone to just outside or on the line...
Forum: 4-Cylinder Tech 06-12-2012, 09:07 PM
Replies: 2
Views: 7,878
Posted By ZohanisBack
Re: Where is EGR valve on 2.3L 2003 Ranger? I'm stumped.

Hey there. This is what it looks like (not really like the older style round EGRs I'm used to):
http://cdn0.autopartsnetwork.com/images/catalog/wp/full/W01331705310MTR.JPG

Replacement...
Forum: 4-Cylinder Tech 06-12-2012, 09:01 PM
Replies: 6
Views: 2,253
Posted By ZohanisBack
Re: Water pump leaks than stops??

Some of us have jobs....that pay bills.....and we might need to wait a few days until a weekend permits a repair on our only commuter... That's all buddy.... A fouled water pump will not overheat...
Forum: 4-Cylinder Tech 06-12-2012, 08:53 PM
Replies: 12
Views: 11,729
Posted By ZohanisBack
Re: Clutch Replacement?

Hi guys. Just to let you all know I went with the exact parts I listed in my previous post. So far so good and they are all working great with 5k already on it. Things to remember when replacing...
Forum: 4-Cylinder Tech 06-10-2012, 10:40 PM
Replies: 6
Views: 2,253
Posted By ZohanisBack
Re: Water pump leaks than stops??

Done and done... Have two gallons water on hand and I just checked hoses and clamps when I saw the coolant. It was dripping slow and from the bottom of the water pump bolts, so pretty sure it's...
Forum: 4-Cylinder Tech 06-10-2012, 08:14 PM
Replies: 6
Views: 2,253
Posted By ZohanisBack
Re: Water pump leaks than stops??

I got work... Think it will make it until next weekend?

Any advice for the replacement? I know the timing cover and accessory mount needs removal, but that's it, right? Any oversized sockets...
Forum: 4-Cylinder Tech 06-10-2012, 10:48 AM
Replies: 4
Views: 1,811
Posted By ZohanisBack
Re: 1993 ranger 2.3 4cyl hiccups when hot

I just read on this other forum that the problem can sometimes lie in the TPS. But to be honest they were throwing a lot of other codes, too. There are still some systems they list that you can...
Forum: 4-Cylinder Tech 06-10-2012, 10:22 AM
Replies: 6
Views: 2,253
Posted By ZohanisBack
Water pump leaks then stops??

1994 Ford Ranger 2.3L w/ 5spd Tranny: 143k miles.


Yeah, I don't know what the deal is guys. I went up to Idyllwild, CA this weekend and it was fine, I drove to a trailhead and back, and a few...
Forum: 4-Cylinder Tech 06-10-2012, 10:11 AM
Replies: 3
Views: 4,650
Posted By ZohanisBack
Re: 1989 Ranger cranks but won't start

Yes, check for fuel pressure when you first turn the key and the pump primes. If none, move to the fuel pump harness and check for voltage when priming (or listen for the priming when you first turn...
Forum: 4-Cylinder Tech 03-26-2012, 07:53 PM
Replies: 12
Views: 11,729
Posted By ZohanisBack
Re: Clutch Replacement?

You're right.... What about going with a generic clutch, but using a heavier duty one? This one says stage 1. Still reasonable. Can get the flywheel and slave cylinder all under $240 going this...
Forum: 4-Cylinder Tech 03-25-2012, 07:14 PM
Replies: 12
Views: 11,729
Posted By ZohanisBack
Re: Clutch Replacement?

*sigh* Please see the first post for this predicament.....

Back to my previous post, I was just wondering if anyone has had luck with eBay clutches and flywheels.
Forum: 4-Cylinder Tech 03-25-2012, 04:55 PM
Replies: 12
Views: 11,729
Posted By ZohanisBack
Re: Clutch Replacement?

bump! :D
Forum: 4-Cylinder Tech 03-24-2012, 03:44 PM
Replies: 12
Views: 11,729
Posted By ZohanisBack
Re: Clutch Replacement?

Think these are really any good?
...
Forum: 4-Cylinder Tech 03-23-2012, 10:48 PM
Replies: 47
Views: 5,429
Posted By ZohanisBack
Re: Coolant Temp Alert

Just to rule out a gauge calibration problem (unlikely though) I might hook up an old fashioned temp gauge to it again. 250 is definitely a little warmer than it should be running. And it reads off...
Forum: 4-Cylinder Tech 03-23-2012, 10:33 PM
Replies: 12
Views: 11,729
Posted By ZohanisBack
Re: Clutch Replacement?

If I decide to order one online, do you know if the hardened pins/dowels for the pressure plate are included?
Forum: 4-Cylinder Tech 03-23-2012, 04:40 PM
Replies: 12
Views: 11,729
Posted By ZohanisBack
Clutch Replacement?

Hey guys! Just getting ready to replace the clutch...

Not my first time replacing a clutch. I've done it before, but I do have a predicament this time. I drive this truck daily M-F. I want to...
Forum: 4-Cylinder Tech 11-19-2011, 12:18 AM
Replies: 15
Views: 8,498
Posted By ZohanisBack
Re: Heater Not Working

Most likely a clogged heater core, especially if the heater stopped working slowly, a little at a time.
Forum: 4-Cylinder Tech 11-17-2011, 05:56 AM
Replies: 2
Views: 2,035
Posted By ZohanisBack
Re: Check Engine Light Flashing Codes Help (VIDEO)??

And.....you apparently have no idea what I'm doing here. Yes, it is the BULB, but the sequence it flashes tells me the codes the car has... Thank you for the intelligent input. :-/
Forum: 4-Cylinder Tech 11-16-2011, 10:56 PM
Replies: 2
Views: 2,035
Posted By ZohanisBack
Check Engine Light Flashing Codes Help (VIDEO)??

I pulled off this video of me jumping the EEC-IV connections and grabbing the codes. But I can't seem to understand the codes. It seems that right off the bat there is a 111 code (system OK), but...
Showing results 1 to 24 of 24