Ford Ranger Forum - Forums for Ford Ranger enthusiasts!
>
Search Forums
Search Results
User Name
Remember Me?
Password
Forgot Password?
Join Us!
FRF Store
Register
Ranger Pictures
Members List
Social Groups
Search
Today's Posts
Mark Forums Read
Welcome to Ford Ranger Forum
Page 1 of 20
1
2
3
11
>
Last
»
Showing results 1 to 25 of 500
Search took
0.60
seconds.
Search:
Posts Made By:
tomboy
Forum:
General Tech
12-20-2022, 07:48 AM
Replies:
2
Fuel gauge indicator
Views:
372
Posted By
tomboy
Re: Fuel gauge indicator
If the fuel pump was replaced, perhaps the sending unit got damaged, first place I'd start looking.
Forum:
Drivetrain Tech
11-09-2022, 01:47 PM
Replies:
1
Noise From Rear Driver Axle Tube
Views:
1,577
Posted By
tomboy
Re: Noise From Rear Driver Axle Tube
Seems as the axel would have to be warped quite a bit to rub the housing, first thing to do would be to remove the brake drum and look for a dragging brake shoe or out of round drum.
Forum:
Interior Tech
10-21-2022, 08:39 AM
Replies:
1
Another Shifter knob question
Views:
1,334
Posted By
tomboy
Re: Another Shifter knob question
Most likely metric, take the shift knobs to the hardware store, find a bolt that screws in, then order knobs with that size and thread pitch.
Forum:
Drivetrain Tech
10-12-2022, 08:49 AM
Replies:
1
CV Axle - No seal found on passenger side
Views:
1,445
Posted By
tomboy
Re: CV Axle - No seal found on passenger side
Yes, there needs to be a seal at the end of the exstention housing, looking at the third member end of the intermediate shaft, was there a cir clip next to the end of it. If not there needs to be...
Forum:
4-Cylinder Tech
10-07-2022, 03:30 PM
Replies:
3
Cranks but won't start
Views:
1,972
Posted By
tomboy
Re: Cranks but won't start
Check the switch under the passenger side carpet near the top, it's got a reset button on it.
Forum:
General Ford Ranger Discussion
10-05-2022, 08:24 AM
Replies:
6
Found this bolt in my new Ranger door pocket - where did it come from?
Views:
1,268
Posted By
tomboy
Re: Found this bolt in my new Ranger door pocket - where did it come from?
The bold looks to have been used, might check to see if there is body damage, and parts have been changed.
Forum:
Wheels and Tires
09-12-2022, 08:25 AM
Replies:
1
Tire and rim fitment verify 1995 ford ranger 4x4 4wd
Views:
2,270
Posted By
tomboy
Re: Tire and rim fitment verify 1995 ford ranger 4x4 4wd
Might not have any problems, but need to place the wheel on the hub, check for caliper clearance, and if the tire will interfear with making a full right or left turn.
Forum:
General Ford Ranger Discussion
08-29-2022, 11:57 AM
Replies:
2
Parts Diagrams and parts availability - 2001 Ranger 2.3L
Views:
1,127
Posted By
tomboy
Re: Parts Diagrams and parts availability - 2001 Ranger 2.3L
Truck is 20 years old, be lucky of those parts are ever found new, salvage yard parts will be in the same shape as yours. Auto part stors have replacement brake lines and fuel line repair kits.
Forum:
Drivetrain Tech
08-04-2022, 08:32 AM
Replies:
4
no engagement
Views:
1,822
Posted By
tomboy
Re: no engagement
Could be a bad torque converter.
Forum:
Drivetrain Tech
08-04-2022, 08:30 AM
Replies:
2
Manual Trans Hard to Shift in 1st & 2nd Gears
Views:
1,678
Posted By
tomboy
Re: Manual Trans Hard to Shift in 1st & 2nd Gears
When was the last time you checked or changed the trans oil?
Forum:
Electrical Tech
07-30-2022, 04:17 AM
Replies:
2
Ignition System Problem
Views:
2,518
Posted By
tomboy
Re: Ignition System Problem
Sounds like a bad end on the battery cable, clean it and the post really good, mabey a new bolt, and tighten it good. And if it's one with the small plate holding the cable to the connector, remove...
Forum:
Drivetrain Tech
07-26-2022, 08:10 AM
Replies:
1
1994 Ford Ranger XLT; 2.3L, M5OD-R1 Manual - Will Not Shift / Move
Views:
1,702
Posted By
tomboy
Re: 1994 Ford Ranger XLT; 2.3L, M5OD-R1 Manual - Will Not Shift / Move
With the trans out, can you shift it into all gears, and while in gear, turn the input shaft and the output shaft turn without binding?
Forum:
Project Logs
07-11-2022, 10:32 AM
Replies:
1
Timing belt
Views:
876
Posted By
tomboy
Re: Timing belt
Check to make sure everything is lined back up like it was, and check for a pulled apart connector.
Forum:
General Ford Ranger Discussion
07-05-2022, 02:48 PM
Replies:
2
will 1986 4wd ford ranger rims fit a 1988 2wd
Views:
938
Posted By
tomboy
Re: will 1986 4wd ford ranger rims fit a 1988 2wd
Bolt pattern should be the same, center hole might be bigger on the 4x4 wheels, and are both trucks disk or drum brakes?
Forum:
Drivetrain Tech
06-25-2022, 11:13 AM
Replies:
2
Long storie short 2.0 2.3 bell housing bolt patterns
Views:
1,918
Posted By
tomboy
Re: Long storie short 2.0 2.3 bell housing bolt patterns
2.0 and 2.3 look exactually the same, except for the different exhaust manafold and one barrel carb, but with a 2.0 in a 4x4, you might not get out of 3rd gear with hubs locked in.
Forum:
3.0 Vulcan Tech
06-17-2022, 09:32 AM
Replies:
5
Coolant overflow hose
Views:
1,770
Posted By
tomboy
Re: Coolant overflow hose
Take it to an auto parts store, they can match one for you.
Forum:
3.0 Vulcan Tech
06-10-2022, 01:52 PM
Replies:
4
i have a dying problem
Views:
1,828
Posted By
tomboy
Re: i have a dying problem
There is a fuel pump cut off under the mat or behind the kick panel on the passenger side, might check that.
Forum:
3.0 Vulcan Tech
06-07-2022, 05:33 PM
Replies:
8
Possible valve job???
Views:
2,307
Posted By
tomboy
Re: Possible valve job???
Valves are sitting way too low in the seats.
Forum:
Interior Tech
05-23-2022, 05:47 PM
Replies:
1
Sloppy column shifter
Views:
1,416
Posted By
tomboy
Re: Sloppy column shifter
All I can ad is they are metric.
Forum:
3.0 Vulcan Tech
05-16-2022, 10:52 AM
Replies:
8
Possible valve job???
Views:
2,307
Posted By
tomboy
Re: Possible valve job???
The right side head already has two cyl's down by 20 lbs, all the valves and seats are going to be rough and pitted, the seats are going to be pounded out too. Spend a little money and do it right, a...
Forum:
Electrical Tech
05-01-2022, 06:48 PM
Replies:
5
Trailer brake 12v always hot
Views:
762
Posted By
tomboy
Re: Trailer brake 12v always hot
One little led bulb on the controler would take years to drain a battery.
Forum:
Electrical Tech
05-01-2022, 09:45 AM
Replies:
5
Trailer brake 12v always hot
Views:
762
Posted By
tomboy
Re: Trailer brake 12v always hot
I think plug and play has to be ordered when new, but what are you working on? if you're talking about one lug being hot at the bumper plugin, it's for a trailer with aux lights that you can turn off...
Forum:
Suspension Tech
04-26-2022, 04:35 AM
Replies:
3
1988 F&R shocks question
Views:
1,747
Posted By
tomboy
Re: 1988 F&R shocks question
Some rangers used heavy cast metal type I beams, some used stamped steel ones, might be something to do with which one you have.
Forum:
3.0 Vulcan Tech
04-17-2022, 10:24 AM
Replies:
2
3.0L -- Confusing Instructions on Camshaft Position Sensor install
Views:
1,900
Posted By
tomboy
Re: 3.0L -- Confusing Instructions on Camshaft Position Sensor install
Do you have the old CPS, if so you will see a half moon mark where the hold down washer contacted it holding it to the engine. That will give you an idea at what angle the CPS, the back cap on top...
Forum:
General Ford Ranger Discussion
04-04-2022, 05:12 PM
Replies:
5
Tow truck put it in neutral, shifter still in park?
Views:
1,014
Posted By
tomboy
Re: Tow truck put it in neutral, shifter still in park?
Roll under it from the drivers side and see if he just popped the cable off the ball stud, or used cable cutters and cut it off, or dropped the drive shaft.
Showing results 1 to 25 of 500
Page 1 of 20
1
2
3
11
>
Last
»
-- Light
-- Dark