Ford Ranger Forum - Forums for Ford Ranger enthusiasts!

Go Back   Ford Ranger Forum - Forums for Ford Ranger enthusiasts! >
Reload this Page Search Results
Forgot Password? Join Us!
FRF Store Register Ranger Pictures Community Today's Posts Search

Welcome to Ford Ranger Forum

Page 1 of 15 1 2311 Last »
Showing results 1 to 25 of 351
Search took 0.13 seconds. Search: Posts Made By: bjurke
Forum: 4.0 SOHC / 4.0 OHV Tech 05-30-2020, 10:33 AM
Replies: 5
Views: 3,356
Posted By bjurke
Re: Alternative ways to fix a fuel pump problem?

Those pumps were low pressure. Some used 2 fuel pumps. I assume you have replaced the fuel filter already. A bad in tank check valve can cause some of problems you are having. Most likely a bad pump...
Forum: 4-Cylinder Tech 10-26-2019, 08:28 PM
Replies: 10
Views: 2,228
Posted By bjurke
Re: 4.0 engine vibration

Hi. Where'd I am from in Ontario Canada they have a website called the Ontario auto wreckers association or oara for short. There is a search function to search auto parts across the entire province....
Forum: 4.0 SOHC / 4.0 OHV Tech 10-26-2019, 07:52 PM
Replies: 20
Views: 5,698
Posted By bjurke
Re: Oil Type Question

My owners manual says semi synthetic or synthetic oil. Not conventional. I have a 2010 Ford ranger. Maybe you should read your manual.
Forum: 4.0 SOHC / 4.0 OHV Tech 10-23-2019, 02:48 AM
Replies: 20
Views: 5,698
Posted By bjurke
Re: Oil Type Question

Because of the timing chain issues in this motor use best oil you can afford. I use synthetic only. The owners manual does not say high mileage or conventional oil.
Forum: Electrical Tech 10-17-2019, 07:26 AM
Replies: 7
Views: 1,108
Posted By bjurke
Re: Break lights don't work

since signal lights work wiring from front of truck is good because signals and brakes is a common circuit. Problem has to be inside the cab. Assuming multifunction switch is ok(replaced?) Check...
Forum: General Ford Ranger Discussion 10-10-2019, 12:51 PM
Replies: 9
Views: 1,075
Posted By bjurke
Re: Running rough after plugged cat replaced

Four thoughts on this. I would replace plugs if not close to new. Air filter same idea. Third do a compression test on motor. Slight possibility of cracked head or valve. You did create enough back...
Forum: General Tech 10-06-2019, 03:12 PM
Replies: 7
Views: 3,389
Posted By bjurke
Re: ABS activates turning left slowly!

My idea is based on what happened to my 2010 ford ranger. In that truck running one tire that has a different rolling circumference would trigger traction control-antilock issues. On my truck 1 inch...
Forum: General Ford Ranger Discussion 05-22-2019, 01:26 PM
Replies: 101
Views: 14,863
Posted By bjurke
Re: highway RPMs?

for best highway mileage 3.55 but if you plan to off road 4.1. I am 2000 rpm at 60 mph. running 29 inch tires. gas mileage over 20 mpg. vehicle not lifted.
Forum: 4.0 SOHC / 4.0 OHV Tech 05-06-2019, 10:13 PM
Replies: 4
Views: 1,187
Posted By bjurke
Re: Bad Rotton Egg Smell after changing plugs and wires

put the old plugs back in. that way you know if its plugs or convertor.
Forum: 4.0 SOHC / 4.0 OHV Tech 05-06-2019, 10:02 PM
Replies: 5
Views: 1,284
Posted By bjurke
Re: P0171 code

when i had this problem the wireing was burnt off to the egr valve on a 2010
Forum: Wheels and Tires 05-06-2019, 09:52 PM
Replies: 3
Views: 3,113
Posted By bjurke
Re: Ford: P235/75R15 all season Unacceptable for 1997??

the problem with that truck is it is light in the back end. i am from canada and i run snow tire 4 months dec to march and all seasons the rest of the year. if you are going off road then all...
Forum: Wheels and Tires 04-14-2019, 11:51 AM
Replies: 7
Views: 2,312
Posted By bjurke
Re: TPMS Replacement

on my ranger.2010. activates at 28 psi so lower one tire to 20 psi and if activates when driving it works. if not then not activated and need work. can take a few miles to activate. mine took 10...
Forum: 4.0 SOHC / 4.0 OHV Tech 04-10-2019, 06:44 PM
Replies: 3
Views: 2,643
Posted By bjurke
Re: Fuel pump issue.

four other possibilities. fuel filter replacement and the fuel pressure regulator located on fuel rail under hood and of course a worn out fuel pump and a plugged sock which covers intake for fuel...
Forum: 4-Cylinder Tech 04-10-2019, 06:26 PM
Replies: 7
Views: 1,219
Posted By bjurke
Re: Ford Ranger

because you do not have any keys you have to wipe computer the memory of all key codes. believe it can only at dealership with their computers
Forum: 4.0 SOHC / 4.0 OHV Tech 04-10-2019, 06:18 PM
Replies: 22
Views: 9,509
Posted By bjurke
Re: Leaking Thermostat housing

one thought on this. when i replaced my thermostat i used rtv sealant which is a type of high temp silicone. no leaks on the first try.
Forum: Exhaust and Mufflers 04-10-2019, 05:57 PM
Replies: 1
Views: 2,786
Posted By bjurke
Re: Lean Code Bank 1

one other possibility. i have a 2010 ranger. wiring harness was resting on top of motor and egr valve wiring was burnt through so egr valve was not working. after i elevated harness and replaced bad...
Forum: 4.0 SOHC / 4.0 OHV Tech 04-10-2019, 05:50 PM
Replies: 3
Views: 1,599
Posted By bjurke
Re: 6cyl,4L SOHC, remanufactured engine from Ford. Remanufactured ford engine.

first oil change conventional oil after that synthetic. i use 5w30 8 months of year. other 4 months 5w20 because -20f in winter here for better winter starting.
Forum: How-To Submissions 08-15-2018, 09:27 PM
Replies: 122
Views: 95,126
Posted By bjurke
Re: How To: Fuel Filter replacment on 2001-2011 Ranger

The only problem with that is if it is made like my 2010 ranger is the spring clamp is sized for a certain filter size. Not sure how secure it will be with the wrong size filter. I get my filters...
Forum: General Ford Ranger Discussion 06-13-2018, 09:06 AM
Replies: 7
Views: 1,216
Posted By bjurke
Re: 2011 Ford ranger front end squeaking

I had a 2002 mazda pickup and when the tie rod ends went i heard a sound like you describe. 6 months before the tie rods failed i heard all the time whenever i hit a bump.
Forum: 3.0 Vulcan Tech 06-01-2018, 05:49 PM
Replies: 4
Views: 2,414
Posted By bjurke
Re: Engine stumbles with acceleration at low rpm

I assume your map is ok and you have cleaned it. Air filter good. Would scan motor . Probably lean running issue.fuel pump. Vacuum leaks. Intake manifold gasket leaks. Cracked heads. I assume your...
Forum: 4.0 SOHC / 4.0 OHV Tech 05-08-2018, 11:23 AM
Replies: 4
Views: 1,869
Posted By bjurke
Re: 98 ranger 4.0 lean in both banks puzzled

I previously had this and the wiring was burnt through for the egr valve causing a non working egr valve. Also a bad fuel pump can cause this.ie low pump pressure
Forum: 4.0 SOHC / 4.0 OHV Tech 04-23-2018, 04:37 PM
Replies: 8
Views: 3,776
Posted By bjurke
Re: Rattle Sound around 3000 RPM

It is possible you need to replace timing chain tensioners. There are 2 of them. would also consider draining oil into oil drain pan and check bottom of pan for any small pieces of plastic which...
Forum: Electrical Tech 04-12-2018, 12:29 AM
Replies: 7
Views: 1,452
Posted By bjurke
Re: 2011 no high beams

I had a problem like yours and it was the multifunction switch. the internal metal for the switch overheats easily warps burns and fails. Do not use the flash to pass feature unless absolutely...
Forum: 4.0 SOHC / 4.0 OHV Tech 04-11-2018, 11:56 PM
Replies: 10
Views: 2,143
Posted By bjurke
Re: Help Identify Weird Noise

There is also a slight possibility related to your fuel pump especially if fuel filter not replaced recently.
Forum: 4.0 SOHC / 4.0 OHV Tech 02-26-2018, 02:48 PM
Replies: 2
Views: 1,108
Posted By bjurke
Re: Bad Valve?

If it was me I would rebuild the head totally with the bad valve but do a close visual inspection of cylinder 1. There is a possibility of a bad cylinder or rings. If that is the case it may be...
Showing results 1 to 25 of 351
Page 1 of 15 1 2311 Last »