Ford Ranger Forum - Forums for Ford Ranger enthusiasts!

Go Back   Ford Ranger Forum - Forums for Ford Ranger enthusiasts! >
Reload this Page Search Results
Forgot Password? Join Us!
FRF Store Register Ranger Pictures Community Today's Posts Search

Welcome to Ford Ranger Forum

Page 1 of 3 1 23
Showing results 1 to 25 of 53
Search took 0.16 seconds. Search: Posts Made By: 2ZZGE05
Forum: 4-Cylinder Tech 09-29-2011, 04:49 PM
Replies: 7
Views: 2,061
Posted By 2ZZGE05
Re: 2010 2.3l mpg?

I wish I get 25 mpg. I get 18-20mpg on my '03.
Forum: How-To Submissions 09-14-2011, 11:09 PM
Replies: 122
Views: 95,141
Posted By 2ZZGE05
Re: How To: Fuel Filter replacment on 2001-2011 Ranger

Did this in about 15mins, stupid clips were hurting my fingers and I my tshirt got raped with about 4oz of gas lol
Forum: How-To Submissions 09-12-2011, 11:38 PM
Replies: 42
Views: 40,764
Posted By 2ZZGE05
Re: How To: Replace front brake pads

I mean... you could push the pistons back without opening the system but you'll be pushing all that dirty fluid past your combination valve and brakes lines which can get damaged.
The best way is...
Forum: 4-Cylinder Tech 09-10-2011, 01:15 AM
Replies: 14
Views: 5,479
Posted By 2ZZGE05
Re: 2010 ranger xl 4 cyl... radiator cap???

You gotta just drain the coolant from the bottom of the radiator and from the block then refill through the res tank.
Forum: 4-Cylinder Tech 09-10-2011, 01:12 AM
Replies: 8
Views: 1,970
Posted By 2ZZGE05
Re: starting to run hot

Could be as simple and cheap as a rad cap. The valves/seal in the cap could be bad and not pressurizing the system causing it to boil.
Forum: 4-Cylinder Tech 09-10-2011, 01:08 AM
Replies: 1
Views: 3,315
Posted By 2ZZGE05
Re: 2003 2.3L - Engine running rough

The A/C compressor won't be the problem. It's suppose to engage and disengage every few seconds. It's a cycling clutch system.
In regards to your engine drivability, the only thing you changed was...
Forum: How-To Submissions 09-10-2011, 12:20 AM
Replies: 42
Views: 40,764
Posted By 2ZZGE05
Re: How To: Replace front brake pads

The order is correct. But anytime you install new pads you have to push the pistons back the entire way so the new pads fit. Since you open system up to push back the pistons, you must bleed all four...
Forum: How-To Submissions 09-03-2011, 08:12 PM
Replies: 42
Views: 40,764
Posted By 2ZZGE05
Re: How To: Replace front brake pads

The safest way to compress the pistons back in the bores is to have a hose attached to the bleeder screw and open it. As you compress, the fluid will come out as opposed to being forced back into the...
Forum: 4-Cylinder Tech 06-30-2011, 08:04 AM
Replies: 14
Views: 12,611
Posted By 2ZZGE05
Re: changing pcv valve 2003 ranger 2.3

It is a closed system. It's recycled through the intake, like you said, making it closed. Open means you'd have a breather filter open to the atmosphere.

----------



Sure no prob. I'll take...
Forum: 4-Cylinder Tech 06-29-2011, 07:50 PM
Replies: 7
Views: 1,609
Posted By 2ZZGE05
Re: How hard to do turbo setup?

If you're not looking to boost too much, you can have a turbo with stock internals. Typically it's no more than 7 pounds. If you wanna push more you'd have to build your valvetrain and pistons.
Forum: 4-Cylinder Tech 06-29-2011, 07:45 PM
Replies: 14
Views: 12,611
Posted By 2ZZGE05
Re: changing pcv valve 2003 ranger 2.3

Well, the PCV isn't exactly open to a breather. They used too. They're recycled and are all closed systems in modern cars.

I'll be doing it on my '03 Mazda B2300 next week. Mine's a 2.3 inline 4...
Forum: Introduce Yourself 06-29-2011, 07:39 PM
Replies: 24
Views: 7,145
Posted By 2ZZGE05
Re: Mazda b2300

Like me! lol Welcome!!
Forum: General Tech 06-21-2011, 11:24 AM
Replies: 4
Views: 992
Posted By 2ZZGE05
Re: WTB new parts?

Cool I'll check them out.

JY?? lol
Forum: Exterior Parts 06-21-2011, 10:44 AM
Replies: 73
Views: 4,432
Posted By 2ZZGE05
Re: 01-03 Clear headlights with corners.

Will these fit a 2003 Mazda B2300? The corners look like they do but idk about the headlights.
YGPM for shipping.
Forum: Interior Tech 06-21-2011, 10:41 AM
Replies: 1
Views: 841
Posted By 2ZZGE05
Re: wiper/ winder cleaner control not working

Could be the switch for the windshield wiper/washer has gone bad.
You can check if the motor still work. Just check to make sure it's receiving power. if it does than the switch is bad.
Forum: General Tech 06-21-2011, 10:39 AM
Replies: 4
Views: 992
Posted By 2ZZGE05
WTB new parts?

I have a 2003 Mazda B2300, same as the '03 rangers and was curious if there's a realiable online store for new parts. My coolant reservoir has a grip of cracks and looks like it will be giving out...
Forum: General Tech 06-21-2011, 10:36 AM
Replies: 6
Views: 1,945
Posted By 2ZZGE05
Re: I can't align my truck!!!! Please help!

Exactly,
ires can have a big part in pull along with brakes. If you've aligned is to spec on an alignment rack and still pulls, you got an issue somewhere else. Check the tire wear, brakes or...
Forum: General Tech 06-21-2011, 10:34 AM
Replies: 12
Views: 3,239
Posted By 2ZZGE05
Re: rotors warped at 18,000 miles

Did the rotors have new pads or used pads?
Used pads have a wear pattern that can warp a rotor pre-maturely.
Or continous hard stops or excess heat was placed on the rotors and warped them.
Forum: Electrical Tech 06-07-2011, 10:08 AM
Replies: 4
Views: 1,655
Posted By 2ZZGE05
Re: Break Light/ Signal Light Gremlins.....Please Help!!!

Could be just a loose wire to the harness of the taillight or the ground on the blub maybe be going in and out due to what you're saying about the light coming on then turning off later. Check that...
Forum: Electrical Tech 06-07-2011, 10:04 AM
Replies: 2
Views: 1,044
Posted By 2ZZGE05
Re: 94 2.3L Help Identifying Loose Wire

Is the wire a solid yellow or does it have a color in it. Can't tell from the pic.
Forum: Electrical Tech 05-25-2011, 11:13 AM
Replies: 17
Views: 27,981
Posted By 2ZZGE05
Re: 2004 Ranger Edge Complete Full Color Wiring Diagram

oooo so colorful lol
Forum: Electrical Tech 05-22-2011, 09:19 PM
Replies: 14
Views: 3,099
Posted By 2ZZGE05
Re: WTF With these Monitors and Smog... HELP

The thermostat looks to be stuck open.
Do you have an O2 behind the cat??
Forum: Electrical Tech 05-20-2011, 03:24 PM
Replies: 8
Views: 3,402
Posted By 2ZZGE05
Re: Blower Motor Gremlin

You sure??

http://i14.photobucket.com/albums/a310/mrquackquack/BMC.gif

This is the blower motor wiring schematic for a 2000 Ford Ranger 4.0 =]

PUNISHER,
Look at the electrical schematic and...
Forum: Electrical Tech 05-20-2011, 03:15 PM
Replies: 8
Views: 2,927
Posted By 2ZZGE05
Re: Electrical Problems Running Battery Down?

Looks like you have a short to power with the interior light circuit. Once the fuse is popped in the circuit is complete and it is getting power somewhere else instead of the switch.
Check the...
Forum: Electrical Tech 05-20-2011, 08:31 AM
Replies: 14
Views: 3,099
Posted By 2ZZGE05
Re: WTF With these Monitors and Smog... HELP

i looked into it and yours does require OBDII. Do you have an O2 sensor after your cat?

could be a computer issue. how much was your replacement computer?
Showing results 1 to 25 of 53
Page 1 of 3 1 23