Ford Ranger Forum - Forums for Ford Ranger enthusiasts!

Go Back   Ford Ranger Forum - Forums for Ford Ranger enthusiasts! >
Forgot Password? Join Us!

Welcome to Ford Ranger Forum

Showing results 1 to 25 of 53
Search took 0.03 seconds.
Search: Posts Made By: mrmitch
Forum: General Tech 01-30-2014, 08:34 AM
Replies: 6
Views: 6,034
Posted By mrmitch
Re: How to remove steering wheel cover

thanks I will take a look!
Forum: General Tech 01-30-2014, 07:41 AM
Replies: 6
Views: 6,034
Posted By mrmitch
Re: How to remove steering wheel cover

Whatever piece will let me get in there and check for a bare wire from the OverDrive. My fuse keeps blowing. Have seen other posts about this wire. I have never taken apart the steering wheel. It...
Forum: General Tech 01-29-2014, 10:32 PM
Replies: 6
Views: 6,034
Posted By mrmitch
How to remove steering wheel cover

I need to check for a bare wire on my O/D to see if that is causing my fuse #2 to blow. How do I go about removing the steering wheel cover?
Forum: Electrical Tech 01-29-2014, 10:27 PM
Replies: 0
Views: 799
Posted By mrmitch
Fuse 2 blowing

I have read a lot of the old posts about this. My question is how do I get the plastic cover off the steering wheel to check for a bare wire on O/D?
Forum: Exterior Parts 02-08-2011, 09:45 AM
Replies: 4
Want to Buy: door sill/threshold
Views: 2,295
Posted By mrmitch
Re: door sill/threshold

is sill/threshold the correct name so I can find it elsewhere? I don't necessarily want a SS one. thnx
Forum: Exterior Parts 02-07-2011, 02:27 PM
Replies: 4
Want to Buy: door sill/threshold
Views: 2,295
Posted By mrmitch
door sill/threshold

I have a 2002 Ranger XLT ext. 2dr
I am looking for a sill piece that screws down on the door threshold(passenger side). Mine is plastic and it cracked.
Forum: Suspension Tech 11-17-2010, 09:41 PM
Replies: 0
Views: 533
Posted By mrmitch
using locktite on inners

do you have to use locktite when installing the inner tie rods in the rack?
Forum: Suspension Tech 11-17-2010, 09:40 PM
Replies: 1
Views: 983
Posted By mrmitch
Re: tie rods-baffled

I bought NAPA tie rods(inners and outers) anyone use these? Is there a left and right-or are they interchangeable???
Forum: Suspension Tech 11-17-2010, 09:38 PM
Replies: 7
Views: 1,279
Posted By mrmitch
Re: Haynes manaul lame

so what manual is the best for a 2003 ranger?
Forum: Exterior Parts 11-15-2010, 11:09 PM
Replies: 6
Want to Buy: skid plates
Views: 1,276
Posted By mrmitch
Re: skid plates

there has got to be a spare one around somewhere. I saw a factory one at a body shop last week(it belonged to the truck that was being worked on). I bought a used plastic one, but that ain't gonna...
Forum: Exterior Parts 11-15-2010, 08:54 AM
Replies: 6
Want to Buy: skid plates
Views: 1,276
Posted By mrmitch
Re: skid plates

No, I am looking for the metal one
Forum: Exterior Parts 11-14-2010, 09:30 PM
Replies: 6
Want to Buy: skid plates
Views: 1,276
Posted By mrmitch
skid plates

I am looking for the front plate(under radiator) for my 03 xlt. Thought maybe someone on here would have one.
Forum: General Tech 11-14-2010, 09:17 PM
Replies: 7
Views: 4,695
Posted By mrmitch
Re: how to get at those tie rods?

I replaced both sides inner/outer tie rods and shocks. Much better. The inners ended up being easy(hopefully I got them tight enough with the rental tool) and the boot was no problem. My alignment...
Forum: Suspension Tech 11-04-2010, 07:46 PM
Replies: 1
Views: 983
Posted By mrmitch
tie rods-baffled

Is there is a right and left tie rod? The parts don't specify that there is. My right tie rod was bad. Replaced right and left inners/outers. I checked my settings. Now my alignment is terrible. What...
Forum: Suspension Tech 11-04-2010, 01:16 PM
Replies: 2
Views: 1,461
Posted By mrmitch
tightening shocks

I am installing rancho shocks. should I tighten them to specs while it's jacked up or on the ground? thanks
Forum: Suspension Tech 11-03-2010, 07:01 PM
Replies: 7
Views: 6,347
Posted By mrmitch
Re: control arm bushing replacement

I thought it was replaceable because it has a bolt running through it.
Forum: General Ford Ranger Discussion 11-02-2010, 09:51 PM
Replies: 6
Views: 1,691
Posted By mrmitch
Re: Haynes Repair Manuals

where is the inner tie rod install instructions in the Haynes??
Forum: Suspension Tech 11-02-2010, 09:46 PM
Replies: 7
Views: 6,347
Posted By mrmitch
Re: control arm bushing replacement

I want to take the upper arm off only to replace the bushings. Can I reinstall the same arm and ball joint?
Forum: Suspension Tech 11-02-2010, 10:37 AM
Replies: 7
Views: 6,347
Posted By mrmitch
control arm bushing replacement

If I want to replace the control arm bushing(upper) can I loosen the ball joint to take the arm out and replace the same ball joint?

03 4.0L
Forum: Suspension Tech 10-29-2010, 09:50 PM
Replies: 7
Views: 1,279
Posted By mrmitch
Re: Haynes manaul lame

no I got that part. I've used Haynes before. I just can't believe that its not in there.
Forum: Suspension Tech 10-29-2010, 09:49 PM
Replies: 6
Views: 1,490
Posted By mrmitch
Re: is this worth the money

Is there a replacement clamp for the inner boot?
Forum: Exterior Tech 10-29-2010, 09:14 PM
Replies: 12
Views: 1,715
Posted By mrmitch
Re: trying to figure out what this shield is??

Be glad to, but he hasn't found a way to ship it yet. It's large.
Forum: Exterior Tech 10-29-2010, 08:55 PM
Replies: 12
Views: 1,715
Posted By mrmitch
Re: trying to figure out what this shield is??

Anyone know how to find it on a parts website? don't know what they call it.
Forum: Suspension Tech 10-29-2010, 08:37 PM
Replies: 1
Views: 18,067
Posted By mrmitch
front end suspension diagram

Anyone know of a link to a diagram of front suspension on a 2003 xlt ranger?
Forum: Suspension Tech 10-29-2010, 08:30 PM
Replies: 7
Views: 1,279
Posted By mrmitch
Haynes manual lame

I got a Haynes manual for a 2001-2005 My first job was to be an inner tie rod change. Couldn't find it in the book anywhere?? Where is the rack and pinion page? Am I missing it? Or is the manual that...
Showing results 1 to 25 of 53