Ford Ranger Forum - Forums for Ford Ranger enthusiasts!

Go Back   Ford Ranger Forum - Forums for Ford Ranger enthusiasts! >
Reload this Page Search Results
Forgot Password? Join Us!
FRF Store Register Ranger Pictures Members List Social Groups Search Today's Posts Mark Forums Read

Welcome to Ford Ranger Forum

Page 1 of 2 1 2
Showing results 1 to 25 of 50
Search took 0.48 seconds. Search: Posts Made By: Mirage
Forum: How-To Submissions 03-15-2013, 07:41 AM
Replies: 748
Views: 182,614
Posted By Mirage
Re: How to: Rear disc brake conversion for stock Ranger rear end

Just wondering, no modification or replacement of master cylinder? And no problems with rear ABS?
Forum: 4-Cylinder Tech 03-12-2013, 04:49 AM
Replies: 5
Views: 1,003
Posted By Mirage
Re: 1996 4 cyl Manual - 50 State vehicle?

As long as it has a working EGR valve, and a non-modified exhaust you should be ok. If the ERG is missing or been blocked off you will run into problems here in CA. And it could get expensive to...
Forum: General Ford Ranger Discussion 03-12-2013, 04:23 AM
Replies: 14
Poll: What to do?
Views: 838
Posted By Mirage
Re: What to do?

Personally, I would keep it. As you said, it will be paid off, it has a bed for hauling, which you might need if you do get hitched, and move. And look around a while for exactly what you want in...
Forum: Drivetrain Tech 03-12-2013, 04:11 AM
Replies: 6
Views: 1,397
Posted By Mirage
Re: Ongoing Transmission Problems

Re-read the original post and the thing that strikes me is that you say it gets worse as things heats up. That tells me that either the trans is low on fluid, or the fluid is no longer lubricating...
Forum: 4-Cylinder Tech 03-12-2013, 03:59 AM
Replies: 6
Views: 2,250
Posted By Mirage
Re: 1999 Ford Ranger 2.5L 2wd has horrible miss

Didn't have a problem with the engine running on after turning the key off, but it refused to idle at a reasonable rpm, and rarely dropped rpm when shifting. Acted kind of erratic as far as idle...
Forum: Drivetrain Tech 03-11-2013, 08:42 AM
Replies: 6
Views: 1,397
Posted By Mirage
Re: Ongoing Transmission Problems

My first recommendation would be to change your tranny fluid. If you already have, then make sure it's full. If it's low it could be causing dry spots on the shift rails, as these are lubricated by...
Forum: 4-Cylinder Tech 03-11-2013, 05:10 AM
Replies: 6
Views: 2,250
Posted By Mirage
Re: 1999 Ford Ranger 2.5L 2wd has horrible miss

JMD90,

Not exactly sure on the 2.5L, but the evap code is a familiar one on the 2.3L engines. Don't ignore it. Take a look at the evap hoses, make sure they aren't rotted away. Also check the...
Forum: 4-Cylinder Tech 03-06-2013, 10:34 AM
Replies: 25
Views: 2,079
Posted By Mirage
Re: Bob Reid

Do you feel any vibration? My gut tells me if you've already gone through the front end, then maybe look at your driveshaft. Look for any looseness or dents in the shaft tube. Also look to see if a...
Forum: General Ford Ranger Discussion 03-04-2013, 06:09 AM
Replies: 3,099
Views: 299,617
Posted By Mirage
Re: How many miles do you have on your Ranger?

Just hit 240,000 on my 96 B2300. Still runs strong and it's been the most dependable car/truck I've ever owned.
Forum: Interior Parts 02-21-2013, 08:28 PM
Replies: 1
Want to Buy: Sun Visors
Views: 532
Posted By Mirage
Sun Visors

Hi All,,

Looking for a pair of TAN, lighted, sun visors, that are in good to great shape.. If you have them and willing to part with them, shoot me a PM and we'll talk price.

Thanks!
Forum: 4-Cylinder Tech 07-07-2012, 10:14 AM
Replies: 2
Views: 850
Posted By Mirage
Re: High oil pressure issue

I'm not familiar with this particular engine, but I have seen a similar problem on others. The first thing I would do is pull the breather cap and put your hand over it to make a tight seal. Do you...
Forum: 4-Cylinder Tech 07-07-2012, 10:04 AM
Replies: 2
Views: 1,153
Posted By Mirage
Re: 96 ranger 2.3 8 plug heating issues

Here's something you might try... Start with a cold engine.
Remove the radiator cap. Fill the radiator with water and start the engine.
Look into the radiator, but don't put your face directly...
Forum: Drivetrain Tech 05-29-2012, 03:11 PM
Replies: 1
Views: 967
Posted By Mirage
Re: What to replace while it's open?

Haven't had any of your problems so far, but have replaced clutches many, many times. I would suspect that your slave cylinder is going out. Are you loosing clutch fluid? How many miles on the...
Forum: Interior Parts 05-04-2012, 06:44 AM
Replies: 7
Views: 1,120
Posted By Mirage
Re: 98 Cluster With Tach 4x4

Still have this cluster? It should fit a '96 B2300 as well, right? All I really need is the clear plastic cover, but for $40 I may take the whole thing.
Forum: Drivetrain Tech 01-07-2012, 08:14 AM
Replies: 4
Views: 14,011
Posted By Mirage
Re: Elusive timing belt tensioner tool

No problem. And don't be too surprised if the timing marks aren't 100% dead on. I've found that with most of the 2.3's the pointer on either the cam or the oil pump will be just a hair off when you...
Forum: Drivetrain Tech 01-06-2012, 01:11 PM
Replies: 4
Views: 14,011
Posted By Mirage
Re: Elusive timing belt tensioner tool

Did mine last year, and if you are careful, a big screwdriver or pry bar is really all you need. Yeah the special tool would be nice, but like you said, nobody has it. Maybe enlist the help of a...
Forum: Interior Parts 01-06-2012, 12:57 PM
Replies: 17
Views: 3,107
Posted By Mirage
Re: 1997 Mazda b3000/ranger Seats

PM sent.
Forum: Drivetrain Tech 01-03-2012, 07:29 AM
Replies: 16
Views: 50,794
Posted By Mirage
Re: Clutch install walk through?

Had the same leaking problem with mine this weekend. What I found was the cause was I followed the videos too closely. I bench bled the entire system, master AND slave, on the bench.

When I...
Forum: Exterior Tech 12-05-2011, 10:36 AM
Replies: 10
Views: 1,421
Posted By Mirage
Re: 3m tape

Actually there is better stuff out there. I can't remember the brand or common name for it but it is the same stuff they use on helicopter blades to prevent ships and dings. It's a little expensive,...
Forum: Electrical Tech 10-17-2011, 12:41 PM
Replies: 10
Views: 20,141
Posted By Mirage
Re: Turn Signal Problem

If I remember correctly the turn signal and hazard lights use 2 different relays. But just because you hear them clicking doesn't mean they aren't bad. I've run into this problem as well, and could...
Forum: Exterior Tech 09-07-2011, 10:34 AM
Replies: 16
Views: 4,187
Posted By Mirage
Re: re-sealing 3rd brake light

Mine leaked too. Went to Ford, couldn't buy just the gasket, had to by the whole third break light assembly.... $175.00 !!!! Ended up using RTV. Keep in mind mine is from a 96 B2300, but dealer...
Forum: 4-Cylinder Tech 09-01-2011, 03:33 AM
Replies: 27
Views: 6,419
Posted By Mirage
Re: engine running hot, really hot.

Glad you found the problem!
Forum: 4-Cylinder Tech 08-29-2011, 02:18 PM
Replies: 27
Views: 6,419
Posted By Mirage
Re: engine running hot, really hot.

I'm guessing you already checked the coolant level, if not do so. Then let it idle until you start seeing the temp rise. when it reaches or starts to pass the normal point on the gauge (I find every...
Forum: 4-Cylinder Tech 07-06-2011, 01:10 PM
Replies: 16
Views: 5,512
Posted By Mirage
Re: I have no ideas left, please help before I have to scrap my Ranger!

I also have to side with the ECU. Remember these guys default to a "limp home" mode when the ECU dies, and trying to drive it like normal is almost impossible. The fact that you can't communicate...
Forum: 4-Cylinder Tech 11-03-2010, 02:08 PM
Replies: 3
Views: 1,947
Posted By Mirage
Re: Idle RPM not consistent

No problem. Let us know how it turns out.
Showing results 1 to 25 of 50
Page 1 of 2 1 2