Ford Ranger Forum - Forums for Ford Ranger enthusiasts!

Go Back   Ford Ranger Forum - Forums for Ford Ranger enthusiasts! >
Reload this Page Search Results
Forgot Password? Join Us!
FRF Store Register Ranger Pictures Community Today's Posts Search

Welcome to Ford Ranger Forum

Page 1 of 20 1 2311 Last »
Showing results 1 to 25 of 500
Search took 0.08 seconds. Search: Posts Made By: Mag liter
Forum: Drivetrain Tech 11-14-2018, 11:15 PM
Replies: 5
Views: 1,092
Posted By Mag liter
Re: 96 ranger 5 speed trans question

There is a way to do it but it's kind of a bitch to do, I would take the snap ring out of the master cylinder in the cab and pull the push rod back until a little fluid came out then put it all back...
Forum: Drivetrain Tech 11-13-2018, 10:07 PM
Replies: 5
Views: 1,092
Posted By Mag liter
Re: 96 ranger 5 speed trans question

Try to push the clutch all the way to the floor and put it in reverse does it grind at a stop or feel excessively tight? If so I bet you still have air in the hydraulic lines, these systems are a...
Forum: Interior Parts 03-10-2018, 08:40 PM
Replies: 6
Views: 1,927
Posted By Mag liter
Re: 94 Ranger Instrument Cluster

Try changing your speedo cable, 94 was the last year for a speedo cable. They are like 23$ for an oem ford one


Sent from my iPhone using Tapatalk
Forum: Drivetrain Tech 07-04-2017, 02:05 PM
Replies: 3
Views: 1,084
Posted By Mag liter
Re: Driveshaft Search

Find a driveshaft repair place and get it re tubed


Sent from my iPhone using Tapatalk

----------
Forum: Drivetrain Tech 06-30-2017, 11:10 PM
Replies: 5
Views: 1,903
Posted By Mag liter
Re: Ford 7.5 -what's that electrical connector?

I would say its a pickup for the rabs system my old 1994 had the 7.5 rear end with rabs and it had the same sensor and connector. The speedo was driven by cables as well


Sent from my iPhone...
Forum: Drivetrain Tech 06-30-2017, 09:11 AM
Replies: 2
Views: 1,245
Posted By Mag liter
Re: transfer case fluid

Atf should work fine


Sent from my iPhone using Tapatalk
Forum: Off Topic 06-17-2017, 07:45 PM
Replies: 15,475
Views: 678,530
Posted By Mag liter
Re: FRF Watercooler / BS Thread 2016 (V2.0)

Thats one day for me, my ebc pads dust alot and im also hard on my brakes :)



Sent from my iPhone using Tapatalk
Forum: Off Topic 06-15-2017, 04:34 PM
Replies: 15,475
Views: 678,530
Posted By Mag liter
Re: FRF Watercooler / BS Thread 2016 (V2.0)

+1


Sent from my iPhone using Tapatalk
Forum: Off Topic 06-14-2017, 10:48 AM
Replies: 15,475
Views: 678,530
Posted By Mag liter
Re: FRF Watercooler / BS Thread 2016 (V2.0)

Damn i need to work for you id be lucky to get half of that for the same job


Sent from my iPhone using Tapatalk
Forum: Off Topic 06-11-2017, 10:51 PM
Replies: 15,475
Views: 678,530
Posted By Mag liter
Re: FRF Watercooler / BS Thread 2016 (V2.0)

I think you meant to say re branded audi r8


Sent from my iPhone using Tapatalk
Forum: General Ford Ranger Discussion 06-06-2017, 03:49 PM
Replies: 13,540
Views: 829,546
Posted By Mag liter
Re: What did you do to your ranger today thread IV

Rock auto is the best place for parts if you dont need them right away, best prices usually and better than dealing with auto zoo employees
Forum: Drivetrain Tech 06-02-2017, 06:12 PM
Replies: 35
Views: 3,698
Posted By Mag liter
Re: Something is squealing that shouldn't be.

Luk clutch kit is pretty much the oem clutch it also should include the little alignment tool that was mentioned. Make sure you get a motorcraft slave cylinder and throwout bearing assy if your going...
Forum: Drivetrain Tech 06-02-2017, 12:31 AM
Replies: 35
Views: 3,698
Posted By Mag liter
Re: Something is squealing that shouldn't be.

You describe it as a whistle/ howl? That sounds like a bearing or bearings in the transmission if its howling


Sent from my iPhone using Tapatalk
Forum: Drivetrain Tech 05-30-2017, 01:49 PM
Replies: 18
Views: 2,477
Posted By Mag liter
Re: Fluid coming out of the fill plug

Was the truck hot when you checked the level?


Sent from my iPhone using Tapatalk
Forum: Drivetrain Tech 05-23-2017, 06:22 PM
Replies: 10
Views: 1,791
Posted By Mag liter
Re: '94 4x4 Issue

Ah i see, my 1994 the transfer case had never been out before and the exhaust had never been removed so thats why i said a day
Forum: Drivetrain Tech 05-22-2017, 08:00 PM
Replies: 10
Views: 1,791
Posted By Mag liter
Re: '94 4x4 Issue

Just take pictures of the wire cluster then cut apart dont waste a good day pulling the transfer case you can use butt splices and heat shrink tubing and be just as good as factory
Forum: Drivetrain Tech 05-22-2017, 03:38 PM
Replies: 10
Views: 1,791
Posted By Mag liter
Re: '94 4x4 Issue

Take the motor off and it will expose a shaft with a hex on it put a wrench on it and turn might have to try all 3 positions one is 4x4 hi ones 2wheel and one is 4x4 low


94 xlt 5speed 3.0v6
Forum: General Ford Ranger Discussion 05-21-2017, 08:33 PM
Replies: 13,540
Views: 829,546
Posted By Mag liter
Re: What did you do to your ranger today thread IV

Dont get an advance auto or auto zoo unit, get motorcraft for that part my buddy went through 2 advanced auto pumps in 2 months and has now had motorcraft in for 2yrs
Forum: Drivetrain Tech 05-20-2017, 04:39 PM
Replies: 35
Views: 3,698
Posted By Mag liter
Re: Something is squealing that shouldn't be.

Maybe check u joints? Get under the truck and try to violently shake the drive shaft
Forum: General Ford Ranger Discussion 05-19-2017, 07:17 AM
Replies: 13,540
Views: 829,546
Posted By Mag liter
Re: What did you do to your ranger today thread IV

My solution is having all my tools in plastic blow molded cases and i take the sets i might need
Forum: General Ford Ranger Discussion 05-15-2017, 04:35 AM
Replies: 13,540
Views: 829,546
Posted By Mag liter
Re: What did you do to your ranger today thread IV

This is essential especially when the plugs are in near impossible locations (76 corvette cyl 2 6 8) passenger side
Forum: Drivetrain Tech 05-14-2017, 07:52 PM
Replies: 1
Views: 1,531
Posted By Mag liter
Re: Clutch/brake pedal assembly

93 to 97 i would think


94 xlt 5speed 3.0v6
Forum: Drivetrain Tech 05-14-2017, 12:05 PM
Replies: 4
Views: 1,668
Posted By Mag liter
Re: Life expectancy of slave cylinder

Thats how my 94 with the 3.0 was, at 173000 it still grabbed like new when the slave cylinder worked. Mine also would sometimes out of the blue get nice and firm usually after driving for a while on...
Forum: General Ford Ranger Discussion 05-14-2017, 11:26 AM
Replies: 13,540
Views: 829,546
Posted By Mag liter
Re: What did you do to your ranger today thread IV

If you dont have ac they are pretty easy to do. If you have ac it can be a pita
Forum: Drivetrain Tech 05-13-2017, 07:18 PM
Replies: 4
Views: 1,668
Posted By Mag liter
Re: Life expectancy of slave cylinder

Slave Probably going bad, on my old truck (94) it would do the exact same thing first it would last 3 months then it got to lasting a week or 2 and i bled it then traded it in


94 xlt 5speed...
Showing results 1 to 25 of 500
Page 1 of 20 1 2311 Last »