Forum: Drivetrain Tech
10-09-2014, 10:58 AM
|
|
Replies: 2
Views: 499
Re: Auto Trans Bangs in Reverse
In my case it was electronic. It was fixed by removing a bad aftermarket chip plugged into the ECM. It also happened using an ECM from a ranger that was manual trans. and likely had no electronics to...
|
|
Forum: Drivetrain Tech
10-08-2014, 05:49 AM
|
|
Replies: 2
Views: 499
Auto Trans Bangs in Reverse
Just wanted to add this so maybe someone might avoid changing drive train parts unnecessarily. My 99 2.5 auto trans 2wd banged hard in reverse sometimes and hard in D or when manually shifting to 2...
|
|
Forum: Electrical Tech
10-07-2014, 07:47 AM
|
|
Replies: 2
Views: 807
Re: Electrical Problem
AHa!!
I reconnected the old computer, just to confirm the difference, same thing, would not run well or take gas. As I began removing the old one for good from the holder to install the...
|
|
Forum: Electrical Tech
10-07-2014, 05:12 AM
|
|
Replies: 2
Views: 807
Re: Electrical Problem
tried another pump relay when it did it again, little or no change
switched computer with 97 2.3 right when it was doing it, different part numbers, immediately ran great and no engine light....
|
|
Forum: Drivetrain Tech
10-06-2014, 10:18 AM
|
|
Replies: 18
Views: 3,240
|
|
Forum: Electrical Tech
10-06-2014, 06:19 AM
|
|
Replies: 2
Views: 807
Electrical Problem
I have a 99 ranger 4 cyl. I use a 97 for parts, a 96 sorta for parts but worth fixing up, a 92 3.0 I think with not much wrong.
On the 99 I've had a problem where often after driving 20-45 min....
|
