So I finally got my lights in and working. When I got everything plugged in I found out I only had 1 light working. I started doing some test and found out that the plug will go on either direction but will only work in one way. So after I got that figured out I put it all back together.
figured out wher i wanted them
Taped off to minimize paint chipping
measured out and drilled my holes
my biggest drill bit was not quite big enough so i had to make them bigger
pulled the tape off
bolted them down and wired them up
Sorry i dont have any pics of the wiring I did I hooked the power wire to my head light switch and then hooked the ground to my ohc bracket. I also had to drill and cut the roof brace to get the wires through and connected.