Ford Ranger Forum - Forums for Ford Ranger enthusiasts!

Ford Ranger Forum - Forums for Ford Ranger enthusiasts! (http://www.fordrangerforum.com/)
-   General Ford Ranger Discussion (http://www.fordrangerforum.com/general-ford-ranger-discussion/)
-   -   How to Remove/Clean EGR Valve (http://www.fordrangerforum.com/general-ford-ranger-discussion/50118-remove-clean-egr-valve.html)

bassplyer92517 12-29-2011 01:01 PM

How to Remove/Clean EGR Valve
 
So I'm going through my truck checking for vacuum leaks and trying to cancel out any reasons for my rough idle. Its slight, but it threw a P0136 code. Replaced the O2 sensors, now I'm realizing I should've check the truck for vacuum leaks first but oh well. Anyways, I want to clean the EGR valve because I'm sure its got a decent amount of gunk on it since I've never cleaned it. I know where its located just want to make sure I don't break anything. I take the wire/hose off the top, unscrew the one bolt attaching it (that I can see), and then do I just pull or screw it off the pole its sitting on? Thanks for you help guys.

dangermike 01-04-2012 03:48 AM

Re: How to Remove/Clean EGR Valve
 
i believe just pull with a bit of persausion been a while since i did the heads on my old one


All times are GMT -7. The time now is 06:09 PM.