HOW TO: Corner Light turn into Blinker 1998-2000
4 Attachment(s)
So i finally came around to turning my USELESS corner front lamps
into blinking lights. I connected them so that they alternate blinking between the bottom two signal lights and the corner light Here is how: 1.Remove bottom turn signal assembly by removing bottom two screws 2.carefully disconnect the lamp harness from the turn signal assembly 3.cut both wires from the corner lamp harness (black and brown) 4.Tape up so that there are no exposed wires & tuck away safely (I used those two wires to run my HALOGEN Lights) 5.tap into the solid w/ stripe wire and the Brown wire from turn signals 6.connect the Brown wire to the corner lamp brown wire 7. connect the solid w/stripe wire to the black wire from corner lamp 8.tape up everything good and be sure wires are long enough to connect to the corner lamp receptacle 9. re-connect all bulbs back into turn signal assembly 10 . repeat directions on other side 11.now when your lights are on ,the signals will alternate blinking (when lights are off,blinking ONLY works on two bottom lamps) |
Re: HOW TO: Corner Light turn into Blinker 1998-2000
Nice write up I moved it to the how to submissions
|
Re: HOW TO: Corner Light turn into Blinker 1998-2000
Thanks !
I love the alternate blinking! This same method also works on 2001- present |
Re: HOW TO: Corner Light turn into Blinker 1998-2000
Ya there is a how to for 01-2011 trucks
|
All times are GMT -7. The time now is 01:29 PM. |