Ranger Emblems
 

Does anyone know how to take off the ranger emblems on the fenders?
also will the newer emblems fit too?
mine are chipped and look bad and i want to get some new ones:)

2006 + emblems will line up just fine


Get some fishing line and run it up and down will cut through the glue on there. Or since they are not any good anymore just take a flat screw driver and get one side up and pull really hard.

A little heat from a hair dryer first will help also.

If you haven't found any yet here is a place to order. Wayne is a great guy to buy from

thanks alot i should be buying some soon.
one more question, so there is no screws or studs holding it on, just glue?

Exactly. Just some double sided tape.

Yep just double sided tape and alignment pins

Ya just the alignment pins like Dixie said

If you buy one to put on the tailgate you need to clip the alignment pins off

You can also use dental floss or thin string.

i just used a beefy flat head screw driver, but make sure not to dig into your paint with it

Just peel them off with your hands or with fishing string like the one dude said. You can then clean off the residue with WD40.

k thanks I'll be trying it soon :)