Ford Ranger Forum - Forums for Ford Ranger enthusiasts!

Ford Ranger Forum - Forums for Ford Ranger enthusiasts! (http://www.fordrangerforum.com/)
-   General Ford Ranger Discussion (http://www.fordrangerforum.com/general-ford-ranger-discussion/)
-   -   putting whips on my baby (http://www.fordrangerforum.com/general-ford-ranger-discussion/3305-putting-whips-baby.html)

'92RangeRDangeR151 10-11-2009 08:17 PM

putting whips on my baby
 
ok so i have a 92 ranger reg. cab, and i cant decide whether to get 3 or 4 foot whips, can someone give me some advice? thank ya much:)

Rangermuse 10-11-2009 08:21 PM

I have a 4ft and it seems to do great.

'92RangeRDangeR151 10-11-2009 08:25 PM

Thanks man Im Zach Tyer Im new.

Rangermuse 10-11-2009 08:27 PM

Welcome to the site

'92RangeRDangeR151 10-11-2009 08:28 PM

Thank ya Im just a hick kid from iowa

DieHard4rd 10-11-2009 08:46 PM

Depends, does your truck sit out or get in the garage?

If it sees the garage you don't want the antenna's clipping the door as you enter & leave. That can mess up the SWRs or even break the tips.

blueovelboy 10-11-2009 10:15 PM

go with a steel whip on a good spring and strap it to the bumper!!!! or a Lil Wilson magnet mount you could remove it when you need or want the clean look

Fx4wannabe01 10-11-2009 10:21 PM

DO NOT DO DUALS!!! These trucks are WAY to small to have a half way decent running dual setup.


Stay single....biggest you want. I whiped out my 4' firestikII, so bumped up to a 5' firestikII. I also occasionally run a 102" stainless whip. You got a radio in mind? Or just doin' it for looks?

DieHard4rd 10-11-2009 10:28 PM

Cobra 29 is a good basic radio. Have it peaked & tuned.

Fx4wannabe01 10-11-2009 10:31 PM

hehe.....i've confirmed over 25mi perfectly clear transmit/recieve with my peak and tuned 29. Pushin' about 80w out of it too.

Old-skool1972 10-13-2009 05:43 PM

If you run dual's it makes you directional very bad ! If you run one its much better. Most people run 2 just for looks. The reson y most trk drvers run 2 is because of the trailer bleeding the signal.

'92RangeRDangeR151 10-13-2009 06:32 PM

what is directional?

Fx4wannabe01 10-13-2009 11:43 PM

the antenna only shoots out in one direction....for example to the sides or just forward and back. Instead of shooting out in all directions.

FireRanger 10-14-2009 06:20 AM

Dual antennas is called co-phasing. What it does is increase your gain along the lengthwise axis of the truck. So you get a boost in transmit and receive gain in front and behind you. It does not enhance or inhibit off the sides.

Truckers use of it is not because of the trailer but because that ahead and behind them is where they want and need that gain in signal. They're talking to people on the highway, not people somewhere else in la-la-land. So that boost is useful to them.

In order for co-phasing to work properly, you need a specific distance horizonallly between the antennas. Its been awhile but I believe this is about 8ft (1/4 wavelength). This works quite nicely on 18-wheelers because the cabs are HUGE and they can attain that spacing. This is not a happenin' thing on a Ford Ranger. You are getting maybe 1/2 the required spacing and it will not work properly. It looks cool but it is not effective.

The most effective place for a single antenna is smack in the middle of the roof or smack in the middle of a metal cap over the bed. This gives a big even ground plane. Unfortunately since CB antennas have to be so big (usually at least 3ft), rooftop mounts are often not practical. They either look dumb or won't let you fit in a garage. The most popular spot is the back of the cab. Your ground plane and radiation pattern will be uneven and not optimal, but for most of our uses, it is perfectly sufficient. Talking locally to other users within a few miles is typically what most people here do and it works fine.

As far as your 3ft vs 4ft question, it comes down to looks and practicality. It may not fit in a garage at 4ft.

PeterbiltMan89 04-14-2010 07:01 AM

Re: putting whips on my baby
 
I have dual whips mounted off my toolbox that run to a Cobra 29 LTD classic.. They are the 3' whips and the look good.. In my opinion, It just depends on where your gonna mount them and whats gonna make the truck look good.


All times are GMT -7. The time now is 04:02 PM.