What would I have to do to make this fit?
I've got a 1999 Mazda B2500 SE extended cab and am wondering if this will fit?
http://sfbay.craigslist.org/eby/pts/2157848055.html Also, how do these mount to the frame? Is this a good deal? Thanks for helping a newbie start putting mods on... :) |
Re: What would I have to do to make this fit?
Weld would be the best bet
|
Re: What would I have to do to make this fit?
They dont mount to the frame. They mount to the body.
Other then that I dunno if they would even fit the mazda. |
Re: What would I have to do to make this fit?
no, they mount to the body, it just depends on if you have a 4 door or a 2 door, and if the truck that they came off of was the same door set up.
|
Re: What would I have to do to make this fit?
Sell does not list what the door configuration is. I still say they would not be a direct bolt on.
|
Re: What would I have to do to make this fit?
go out and look under your truck for mounting holes on the body, and email that guy and ask him what type of truck they were on.
|
Re: What would I have to do to make this fit?
From the picture they appear to be 4 door brackets
Here is a thread FX4 had with the wrong brackets. CLICK HERE |
All times are GMT -7. The time now is 03:29 AM. |