SAS swap+lift
looking like around 6" of lift all around if not more...
http://www.fordrangerforum.com/membe...underneith.jpg mock up height of the truck http://www.fordrangerforum.com/membe...ght-wheels.jpg this is with the leafs compressed+bilsteins http://www.fordrangerforum.com/membe...-52-41-675.jpg i need some better backspacing for the rims :/ http://www.fordrangerforum.com/membe...t-rear-end.jpg http://www.fordrangerforum.com/membe...about-tall.jpg |
Re: SAS swap+lift
..........what size tires you gunna run? cuz thats rediculously tall.....hell my trucks way shorter than that.
|
Re: SAS swap+lift
What's the cheapest lift I could get around?
|
Re: SAS swap+lift
Quote:
but back to your question these until april and 35"s after Quote:
|
Re: SAS swap+lift
http://www.fordrangerforum.com/membe...-37-54-433.jpg
http://www.fordrangerforum.com/membe...-38-09-259.jpg slight update....been a bit and everything is just about done |
Re: SAS swap+lift
Moar Pichers!
|
Re: SAS swap+lift
Link it lol, good start though
|
Re: SAS swap+lift
Quote:
|
Re: SAS swap+lift
What was it crumpling on, was your running a reg 4link or a double triangulated 4link? Are you planing coils or coilovers?
|
Re: SAS swap+lift
Quote:
|
Re: SAS swap+lift
Engine mount wow thats a little odd dont think Ive seen that before. Yeah wasnt sure if you was going to run coil over looked like the front axle had been shaved clean. Look forward to the build though good luck.
|
Re: SAS swap+lift
Quote:
this is the ranger the 4 link was on http://www.facebook.com/pages/Chimne...d=260454698175 rob does good work and updated that kit on my truck |
Re: SAS swap+lift
Very nice looking, looks like he was only running a parallel 4 link, might want to invest in some limiting straps lol
|
Re: SAS swap+lift
Quote:
|
Re: SAS swap+lift
Will have pics of the sas done up within the next couple of hours front driveline is not installed due to backordered gears
|
All times are GMT -7. The time now is 10:17 PM. |