Ford Ranger Forum - Forums for Ford Ranger enthusiasts!

Ford Ranger Forum - Forums for Ford Ranger enthusiasts! (http://www.fordrangerforum.com/)
-   Electrical Tech (http://www.fordrangerforum.com/electrical-tech/)
-   -   Turn signal problem (http://www.fordrangerforum.com/electrical-tech/103219-signal.html)

Hunter6908 11-24-2013 10:09 PM

Turn signal problem
 
My 93 ranger 5sp 3.0 xlt 2wd keeps blowing the turn signal fuse when put into reverse I replaced the fuse turned my signal on and it works until I put it into reverse then it blows my hazards work my brake lights work but not my reverse or turn signals it even blows if my turn signals are not on when put into reverse

WyldeChild 11-25-2013 03:28 AM

Electrical short somewhere.

Have you messed with the electrical at all recently? Installing or repairing anything? If so, start there.

Hunter6908 11-25-2013 03:53 AM

Re: Turn signal problem
 
All I did was remove the transmission to replace the pilot bearing

2010 11-25-2013 05:20 AM

Did it work fine before removing tranny?

1986 1st gen 11-25-2013 05:52 AM

Probably pinched or gouged a wire while removing transmission

Hunter6908 11-25-2013 06:47 AM

Re: Turn signal problem
 
Thanks guys I'll look into it all yes it work before the trans was pulled

----------

Could it be the reverse light switch wire because it is on top of tranny

Greasemonkey51 11-25-2013 06:54 AM

Quote:

Originally Posted by Hunter6908 (Post 1833324)
Thanks guys I'll look into it all yes it work before the trans was pulled

----------

Could it be the reverse light switch wire because it is on top of tranny

Might be check the shifter plate on top. I've done that instaling trannys in semis lol.

Hunter6908 11-25-2013 08:11 AM

Re: Turn signal problem
 
Shifter plate? Is that what the shifter actually bolts onto?

Greasemonkey51 11-25-2013 08:50 AM

Quote:

Originally Posted by Hunter6908 (Post 1833485)
Shifter plate? Is that what the shifter actually bolts onto?

Yes I believe so..

Hunter6908 11-25-2013 04:44 PM

Re: Turn signal problem
 
I figured it out when I installed the trans I pinched the reverse safty switch between trans and engine block had to remove trans to fix the repair the wires thanks for all the helps guys


All times are GMT -7. The time now is 11:36 AM.