Jsteezy idk how your daily driving your truck with out beating the living shit out of your engine cross member I have 7 inches of suspension dropand and about -1.5° camber in the front and currently 165/80/15 fronts normally 245/45/17 but mine hits on stuff
low 2.3. by engine crossmeber are u talking about the x member that the rack and pinion sits on or the tranny x member. anyway ihave a raised tranny x member and the engine x member scrapes constantly i have to drive it vaery carefully.
Yeah where the rack is. I have a raised tranny crossmember to but yeah I hit my engine cross member on stuff sometimes mine is 7-8
DJM upper and lowers with 3" belltech springs and 1 coil cut out
low 2.3. by engine crossmeber are u talking about the x member that the rack and pinion sits on or the tranny x member. anyway ihave a raised tranny x member and the engine x member scrapes constantly i have to drive it vaery carefully.
Did you have to notch for your tie rods? Seems like they would have to run through your frame at that amount of drop.
__________________ 1997 Ford Ranger 2.3L
It's lowered and stuff. My Build Thread