Re: Driver Side Power Window Motor
it's not terrible to do. remove your door panel (there are many how to's on this), and there will be 4 or 5 large rivets that hold the regulator/motor to the inner door. you will need to drill them out. then there should be two more that hold the regulator to the window glass. they have to come out. use something to prop the glass up (some tape on the top). then you have to get the regulator in the right position to slide it out the largest hole in the inner door.
installation is the opposite. you will need 1/4" rivets to put it back in, or you can use 1/4" bolts. that's what i used. just be careful not to tighten the ones on the glass too much!
Krylon Fusion is for Amateurs.