would lincoln mark 7 seats fit in a 2000 ranger supercab?

__________________
2000 xlt 4x4 offroad package

For an early Birthday present my dad gave me a set of seats from a 07 Ranger. When I removed the passenger seat and set the new one in it didnt line up. The fronts did yet the back wasnt close. I looked at swapping tracks over but I dont believe that will work.

Any ideas what i can do?

__________________
Its a 02 Ranger XLT, 4.0, Flowmaster No Cats, 16" AR Torque Thrust Wrapped In Michelins, 07 Tail Lights and Seats, Headlight Mod, Edge Valance, FX4 Bumper, Powerdome, Buggman Leds front to back, 2 MTX 10's, 1000 Watt Amp, Aux Cord Mod, 15% Tinted Windows, Painted/Chrome Grille, Retrax Sliding Bed Cover, and a Ranger emblem on the tailgate.

ext cab to ext cab, reg cab to reg cab. sounds like you got ones from a different cab. you'll have to find 04+ tracks for the cab you have, tear the seats down and swap them around, or find another set of seats.

__________________
Krylon Fusion is for Amateurs.

Ok maybe someone is on today that can give me a quick hand.
Putting in my 2000 explorer bucket seats, and maybe my explorer full center console.
I removed my passenger side, got the new one in, had to drill two of the holes a little bigger to get it to work, but overall it was easy.
Now im pulling out the driver side. There is a wire harness connector on it, im assuming for airbag, there wasn't one on the passenger old one, but there is one on the new one.
The new driver side one has two connectors, one for the powered seat, and I guess the other one for the airbag. Will my wire connector that is in my truck work ok to plug into the one on the new seat?
Also im assuming I should disconnect the battery and wait, before I pull that connector apart to remove the old seat.

Ok now what is the best way to wire up the powered seat?

If I get this done quick, I may tackle my console this weekend.
I can quickly remove the passenger seat to have access to install it.
I know this is the seat thread and not the console thread, but im kinda nervous about the full console and tinkering with that passenger side airbag switch and stuff that has to be removed.

__________________
1999 Ranger 3.0FFV-ExtCab-4x4-My 99 Build
1998 Ranger 3.0-ExtCab-4x4-PROJECT TRUCK-My 98 Build

not for airbags in a 99, just the seat belt reminder light on the dash. if the new seats have a belt that will work in the shoulder belt, you will probably be fine. worst case, you'll have to put your seat belt on the new seat.

as for wiring the seats, should be two wires. power and a ground. ideally, it would be ran to the fuse box on a 15-20 amp circuit. factory, they are on a non keyed source, hot all the time. would be nice to put it back that way so if you need behind the seats, don't have to turn the truck on to move them.

__________________
Krylon Fusion is for Amateurs.

Great info. Im trying to put jump seats in my 04 xlt 2 door, found some from a 93 2 door, anyone know if they will fit n bolt up??

Finally got some explorer leather Eddie bayed seats and got em for $80 bucks ....

ForumRunner_20121112_124445.jpg

__________________
1998 Ranger 2.5L 5 spd with 250,000 miles as of 1/25/13
MODS

throttle cable mod, alpine head unit, 2009 ford ranger wheels, dumped stock exhaust, L.E.D mustang dome light, tinted windows, L.E.D tachless gauge cluster with hvac, Eddie bauer leather seats need to get wired lol, Ford explorer full length center console.

OK, what's the best used seats to put in my 95 reg.cab?

__________________
95xl 2w drive 4ltr v6 5speed manual

Bauer* damned auto correct lol

__________________
1998 Ranger 2.5L 5 spd with 250,000 miles as of 1/25/13
MODS

throttle cable mod, alpine head unit, 2009 ford ranger wheels, dumped stock exhaust, L.E.D mustang dome light, tinted windows, L.E.D tachless gauge cluster with hvac, Eddie bauer leather seats need to get wired lol, Ford explorer full length center console.

Seems most of the posts here speak to older Rangers, I have a 2007, ext cab, 4 door, with the sport (hard and uncomfortable) seats, can someone address a direct swap for this make.

__________________
2007 Ranger Sport 4x2
Extended Cab 4 Door
Towing Package
Sport Seats
No Mods Yet

Will the 2001 sport trac seats fit in my 2001 ext cab ranger?

Ok, first timer here, have an 04 white delivery ranger standard cab, would like to replace 60/40 vinyl seats with cloth, lookin for easy fix, bolt right in, do i have any options and if so can you point me in the right direction ive been lookin for over a year on ebay and craiglist with no luck, Thank You Devon, 248-396-7602, grenonr@comcast.net, michigan

Would a 2005 Ford Feestyle front seat fit a 2001 Ranger extended cab?

Will the seats from a 98 standard cab fit the 98 extended cab?

__________________
1998 Black Ford Ranger XLT SuperCab 3.0 Vulcan.
Moded with dings, scratchs, scrapes,and a tiny pinch of rust

yes, but will require a complete disassemble to swap the tracks around.

__________________
Krylon Fusion is for Amateurs.