 |
 |
 |
|
#1
12-02-2010, 06:59 AM
|
||||
|
||||
Adding gauges
Have any of you done any aftermarket gauge installations in a 2003 and later Ranger with a/c that look built in and not "hung on". Can't use the A Frame location because of the grab bar, and top of the dash has slope to it above a/c center outlet. If you have done a neat installation would appreciate photos. Looking to do a 3 gauge install - Trans temp, Vacuum and Oil temp. Thanks
__________________
2003 Ranger Edge - Black with black/grey interior. 4.0L engine, cold air induction, cat back exhaust, tune chip. Bilstein shocks, Limited Slip axle, Ultra Gauge 
|
 |
 |
| Register and never see these ads again. | |
|
|
 |
«
Previous Thread
|
Next Thread
»
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| adding a/c | nvr_done | General Ford Ranger Discussion | 3 | 06-03-2010 12:05 AM |
| adding foglights | patrickke | Exterior Tech | 5 | 05-21-2010 03:38 PM |
| 94 Gauges | zatticus | Interior Tech | 0 | 04-21-2010 09:31 PM |
| adding pics | RangerLuc | Site Announcements, Comments and Suggestions | 2 | 12-12-2009 06:18 PM |
| new gauges | gntlbn64 | Interior Tech | 21 | 11-08-2009 08:55 PM |
|
|
 |
|
|
 |
 |
 |
