Hey all,
Both of my cigarette light/chargers pushed in through the dash bezel over the years. Replacing the bezel is nearly $50 via eBay...so I found a cheap $0.69 solution I thought I’d share:
Remove the radio bezel. Buy an o-ring (I used size 1-1/8 x 7/8 x 1/8) from the hardware store and slip it over the inner aluminum cylinder of the cigarette lighter. Steps below.
Note: I had to scrape a bit of the outer o-ring edge away with a razor blade to get this to work. I wish I had taken a photo, but it’s pretty straight forward.
Hope this helps someone out there.
—
Step one, put the o-ring around the smaller cylinder and insert through the front of the dash (oring not shown). I had to scrape a small amount of the oring away to get it to slide in.
Step two: Screw in the larger cylinder from the back. I had to press it in pretty good. Just be careful not to brake anything
Voila!
Sent from my iPhone using Tapatalk