I knew I wanted and a few others wanted to do this mod to finish off the Led swap and never saw any one do it yet. So I thought I would see if I could do it.
Well here we go....
Tools needed:
Soldering Iron
Solder
Small Flat Head Screw Driver
SMD Led's (Color of choice)
Here is how to remove the pods without removing the air bag
Couple pictures to show what I did.
You can kinda see the little nipple that just slips into the hole
Holes the little nipples slip into
Ok now on to the fun part.
You will have to pry them open, Flip them upside down and you will see there are 4 tabs that hold them together.
Next remove the clear rubber cover and you will see the boards we are going to work with.
Now Heat up the soldering iron.
Each SMD Led has a POS and a NEG just like the full size LED's. when you look at them you will see a corner that is cut. Just make sure you put the new ones back on the same way the old one came off.
I found it better to take off one and put the new one on then move to the next one.
After all the soldering was done reverse the steps and put them back in and test them.
BAM! All Blue
Sorry for the bad pics, I had the cell phone handy.