Ford Ranger Forum - Forums for Ford Ranger enthusiasts!

Go Back   Ford Ranger Forum - Forums for Ford Ranger enthusiasts! > > >
Forgot Password? Join Us!

Welcome to Ford Ranger Forum

Reply
 
Thread Tools Search this Thread

  #1  
Old 03-25-2018, 08:49 AM
foosmadman foosmadman is offline
2000 xlt
 
Join Date: Mar 2018
Posts: 3
Default ford...hard to work on

I am just venting here. Ford Ranger pickups are hard to work on. I replaced my passenger window regulator, changed my engine, my upper rear door latch and cable, and have tried to disable my door chime and seat belt dinger. of all these, changing the engine was the easiest part.LOL I tried to silence my door chime. The GEM is blocked by an ac duct. there was an upper screw holding the duct in place that was blocked by the dashboard. I tried to pull my instrument cluster bezel to facillitate removing the steering columnn covers to get to the blue key in wire connector. one screw on that bezel is placed behind a major steel bracket where you cant get to it.....the rivets i had to drill out to replace the upper rear door latch and the window regulator have a stud in the middle of them so the drill bit wont stat centered,,,,,I have tried oil pan removal. I am a great mechanic. I read up online on oil pan removal, and it is a major bitch if it can be done. I could not get my original oil pan off of the first engine. gimme a break....
__________________
2000 XLT vulcan 3.0

Last edited by foosmadman; 03-25-2018 at 09:04 AM.
Reply With Quote
  #2  
Old 03-25-2018, 04:42 PM
Undrstm8ed Undrstm8ed is offline
Habenae Est Dominatus
 
Join Date: Apr 2013
Posts: 1,682
Default Re: ford...hard to work on

All of that is assembled into the I/P and then the I/P is installed into the cab and plugged in. Access is likely near impossible by design. Good news it there's only 6 bolts on the side of the dash, drop the 4 - 15mm bolts for the steering column, and there is a host of bolts across the top near the windshield. I fought with Ford Engineers when I did prototype electrical back in 95' on the 98 Ranger/Explorer program.

The rivets are a pain in the ass, usually you can get a small center punch and knock those studs back and out and the drill bit works fine, otherwise, small angle grinder and zip them out. Larger Regulator rivets.. 4-5 knocks with a air chisel on an angle and done with it.

You should see whats involved in getting a head off of a 2000 Escort 2.0L...
__________________
_______________________

My Build Pg. Threads
+ 93' Ranger Overlanding Build
+ 94' Ranger Bed Overlanding Trailer Build
+ 12 North Industries ~ I Support
Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search


Similar Threads
Thread Thread Starter Forum Replies Last Post
Is it hard to have sex in a ford ranger? trucklover123 General Ford Ranger Discussion 18 07-26-2013 05:30 PM
94 ford ranger 2.3 hard to start when cold Ranger01 4-Cylinder Tech 1 03-22-2013 11:22 PM
Want to Buy: hard tonneau ford for 2001 stepside jloose17 Exterior Parts 0 11-16-2012 09:19 AM
Elected officials hard at work Dang Laugh Factory 8 12-13-2009 12:30 PM
2003 ford ranger hard going into gear? turbo_diesel08 Drivetrain Tech 3 01-17-2009 09:15 AM