Ford Ranger Forum - Forums for Ford Ranger enthusiasts!

Go Back   Ford Ranger Forum - Forums for Ford Ranger enthusiasts! > > >
Forgot Password? Join Us!

Welcome to Ford Ranger Forum

Reply
 
Thread Tools Search this Thread

  #1  
Old 11-30-2014, 03:33 PM
pickupman2007 pickupman2007 is offline
Ford Motor Company
 
Join Date: Jul 2013
Posts: 128
Default Door lock switch repair

How to fix dirty or corroded door lock switch contacts:

Caution: Neither myself of FRF can be responsible if you damage your truck or switch or stab yourself with a screwdriver, so please take your time and use some common sense.

Tools & Supplies:
- #2 phillips screwdriver
- small (pocket) flat blade screwdriver
- electronic contact cleaner
- fine grit sandpaper or emory cloth

This is how i fixed my intermittently working door lock switches on my 2001 edge, not sure which other years may have the same switch.

1. Remove 2 phillips screws holding switch panel to the door and carefully pull the top to remove the clips.

2. Remove door lock switch from switch panel by pressing the metal clips toward the switch on both ends.

3. Remove the electrical connector.

4. Carefully pry the switch from it's housing, alternating sides as necessary, with the small flat blade screwdriver. You want to pry on the inner seam, not the outer one, no need to remove the trim from the top half of the switch.



That should give you these two pieces:





5. Use the sand paper or emory cloth (I used 400 wet/dry paper, cut to a narrow strip.) to clean dirt and/or corrosion from the lower contacts and the spring like contact arms. Please be careful here not to bend the arms. I cleaned the upper contacts to, but our trucks don't appear to use them.



6. Now that you have removed any heavy deposits or corrosion, spray the contacts off the the electronic contact cleaner to remove any lose particles and dust.



7. Snap the switch back into the top part of the housing and reassemble your truck / door and test.

If it works, then you have just saved the cost of new switches. Since I was looking at sending $90 (needed both) I think the $8 or $9 for the contact cleaner and the effort was worth it.
__________________
2001 Ranger 4x4, 4.0 SOHC, Auto
Reply With Quote
  #2  
Old 09-13-2017, 04:55 AM
schutzen-jager schutzen-jager is offline
Learning to use the forums
 
Join Date: Sep 2017
Posts: 1
Default Re: Door lock switch repair

thanks for the tips - did it yesterday - now works great -
Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search


Similar Threads
Thread Thread Starter Forum Replies Last Post
New ignition switch + door lock cylinders for 97' Xlt 4x2 Ext cab 2,3L GreatDane Electrical Tech 5 01-30-2014 12:02 PM
99 ford ranger power door lock/actuator & door ajar switch issue AnnoyingOrange Interior Tech 0 07-06-2013 10:26 AM
Want to Buy: Wtb: Power door lock Switch riverrunnernky Interior Parts 0 03-18-2012 04:05 AM
Want to Buy: Power mirror and power door lock switch. justin murphy Interior Parts 0 02-03-2012 12:29 PM
Door lock hole repair RANGERHEAD Exterior Tech 2 10-16-2011 06:06 PM