Quote:
Originally Posted by Fluxcapacitor
Your halfway there. Only have wiring. One wire you have to decide where you'll tap into it is te speed sensor wire. You can get that signal from both behind the radio and also right at the computer harness in the engine compartment. Grey wire if memory serves me. You also need to tap into your brake pedal and pressure switch as a backup. The harness for your column is right under the dash to the right. You should just be plugging into it as you took the other column out.
|
if you are still monitoring this post, I could use some help on the wiring side.
I am doing a 98 ranger not prewired using 99 explorer for servo plug/wiring and servo.I know servi cable has to be replaced.
steering column was 98-01 explorer column already installed in the ranger.
anyhow if you or anyone else can help with the wiring it would be appreciated