Ford Ranger Forum - Forums for Ford Ranger enthusiasts!

Go Back   Ford Ranger Forum - Forums for Ford Ranger enthusiasts! > >
Forgot Password? Join Us!

Welcome to Ford Ranger Forum

Reply
 
Thread Tools Search this Thread

  #1  
Old 07-15-2009, 01:19 PM
drumz7777 drumz7777 is offline
Learning to use the forums
 
Join Date: Jul 2009
Posts: 7
Default Ford Ranger Timming belt And setting's

--------------------------------------------------------------------------------

Can anybody help me with this question? I have 87 Ford Ranger 2.0 I took the timming belt off to fix the crankseal.Now my timming is out of wack. How do get my timming back? How do set the cam gear/aux gear/crank gear/
Reply With Quote
  #2  
Old 07-15-2009, 01:36 PM
STL STL is offline
...............

 
Join Date: May 2009
Posts: 23,398
Default

Copied from WikiAnswers.com
Quote:
I just replaced the belt off my 86 2.0l four cylinder. Bascially, drain radiator, remove the fan, fan cover, belts, disconnect upper radiator hose and remove alternator to get to distributor easlier. Before removing cover set the engine to Top Dead Center where the cam sprocket to pointing to the marker on cover and crankshaft mark is lining up with tick mark of TDC with the timing pointer also check if the rotor under distributor is pointing to number one cylinder, if not keeping rotating crankshaft in clockwise direction until its close. Don't worry if it don't line up because you will adjust it later. Don't turn the crankshaft counter clockwise because this will throw off the timing belt. Losen the tensioner and remove the belt from the camshaft sprocket without moving it. The timing belt was awfully difficult to remove around the crankshaft, but I got it by kind a bending it and wiggled it and it came out. Putting the new one in is easlier. Ensure the sprockets didn't move and tighten the tensioner. Put everything back on and use a timing light to get it close to 6 degrees TDC by losing the distributor and moving it a little and tighten it and check it again until you are close.
__________________
2005 Edge

Reply With Quote
  #3  
Old 07-15-2009, 01:42 PM
drumz7777 drumz7777 is offline
Learning to use the forums
 
Join Date: Jul 2009
Posts: 7
Default

I will give it a try? Thank's

Last edited by drumz7777; 07-15-2009 at 01:52 PM.
Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search


Similar Threads
Thread Thread Starter Forum Replies Last Post
2000 Ford Ranger Belt Squeaking Issue? Moto 3.0 Vulcan Tech 19 12-12-2014 10:15 PM
Ford Ranger Timming belt And setting's drumz7777 4-Cylinder Tech 5 07-14-2009 07:08 PM
My 2005 Ford Ranger's belt keeps making a High pitch noise....? rickymercer17 General Ford Ranger Discussion 6 12-10-2008 04:20 PM
How do you change the timming belt on the 2000 Ford Ranger? Dan K General Ford Ranger Discussion 1 12-10-2008 03:52 PM
1999 Ford Ranger's belt is chirping.? Matt General Ford Ranger Discussion 2 12-08-2008 07:40 PM