A few days ago my front parking brake cable snapped off. The repair seemed somewhat simple with a $20 replacement cable from Autozone. However, I couldn't figure out how to get the "anchor pin?" at the end of the cable off the assembly. I even found a guide for this procedure as well but still no luck:
https://www.scribd.com/document/3230...stallation-pdf
I could probably bend part of the assembly and get the pin/cable out then put the new one in and bend it back but I would want to avoid doing this if possible. I would be thankful for any help!
I took some pictures of the assembly too:
https://imgur.com/a/R3IzSPF
Edit: My particular truck is a 2003 Ranger but my guess is that the same type of assembly can be found on most if not all Rangers and Explorers.