 |
 |
 |
|
#1
02-04-2016, 01:37 PM
|
||||
|
||||
Transfer case replacement issues
Can the transfer case (the male part that goes into into the transfer case motor) be turned by hand to line up with the new TC motor?
Can I use vice grips on a piece of rubber over the shaft end to turn it to match with the motor? Thanks.
__________________
1998 XLT extended cab 4x4 Splash 
|
 |
 |
| Register and never see these ads again. | |
|
|
|
|
|
#2
02-04-2016, 02:58 PM
|
||||
|
||||
|
Sure, you can turn it by hand. There should be markings on the case itself to indicate what you're in (4hi, N, 4lo).
__________________
2002 Ford Ranger XLT 4x4, ext. cab, 4.0L v6 Superlifted 33x12.5 Duratracs Build Thread: http://www.fordrangerforum.com/proje...ys-02-4x4.html 1995 Ford Ranger STX 4x4 ext. cab 4.0l v6 SOLD
|
|
|
 |
|
|
| Tags |
| 4.0, 4.0 engine, 4x4, case, transfer |
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | Search this Thread |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Transfer case | Rilz | Drivetrain Tech | 1 | 11-08-2015 01:11 PM |
| Transfer Case Issues 4WD and 4 Low | lukehowell10 | 4.0 SOHC / 4.0 OHV Tech | 2 | 06-26-2015 05:55 PM |
| 02 Transfer Case | Tim B | Drivetrain Tech | 0 | 12-06-2013 02:22 PM |
| Replacement Transfer Case | PHAL23 | Drivetrain Tech | 1 | 03-19-2013 06:35 PM |
| Issues with my new truck. transfer case? | jczerski | Drivetrain Tech | 0 | 03-12-2012 03:46 PM |
|
|
 |
|
|
 |
 |
 |
