 |
 |
 |
|
#1
11-21-2009, 05:45 AM
|
|||
|
|||
crankshaft pulley
I have a 1995 ranger 2.3 and my crankshaft pulley does not have holes for a puller. How do I remove it?
Last edited by ranger danger; 11-21-2009 at 06:18 AM. 
|
 |
 |
| Register and never see these ads again. | |
|
|
|
|
|
#2
11-21-2009, 07:33 AM
|
||||
|
||||
|
Pull the bolt in the center, and you will have to pry it off should come off some what easy. They are just pressed on there
|
|
|
|
|
|
#3
11-21-2009, 09:21 AM
|
|||
|
|||
|
I will try that, thank you.
|
|
|
 |
«
Previous Thread
|
Next Thread
»
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1996 Ranger crankshaft position sensor | vang0017 | 4.0 SOHC / 4.0 OHV Tech | 5 | 06-07-2011 06:59 PM |
| How to remove Crankshaft Pulley + Hub? | 4 banger ranger | 4-Cylinder Tech | 11 | 10-07-2009 08:34 PM |
| stripped power steering pump pulley | vehder | 4-Cylinder Tech | 2 | 09-14-2009 11:39 AM |
| underdrive pulley on 4.0L SOHC | 02slammedranger | 4.0 SOHC / 4.0 OHV Tech | 6 | 07-09-2009 11:14 AM |
| Idler Pulley Hardware Question | xmicros | 4-Cylinder Tech | 1 | 05-05-2009 08:24 PM |
|
|
 |
|
|
 |
 |
 |
