so my lights dont come on when I press the brake but they flash with the hazards on. checked/replaced fuses per manual and they still wont come on. so the question is what is the logical progression do get this fixed?
all fuses good w/ correct amps
bulbs good since they flash with hazards
anything else i should check besides wires?

__________________
96 Ranger XLT 2.3L 2wd:
camo headliner, throttle cable mod, ignition coil mod, removed sway bar, 3" body lift, dual exhaust, 31x10.5r15 BFG

Mmmm other than the wires I'd say pull the flasher switch out and clean it. Try to giggle it a bit (pull it out and put back it) and see if it works.

Brake light switch or wiring.

--1993 ford ranger ext cab 3.0 v6--

__________________
1993 ford ranger 3.0 v6

where is the brake light switch and how do i know if its bad?

__________________
96 Ranger XLT 2.3L 2wd:
camo headliner, throttle cable mod, ignition coil mod, removed sway bar, 3" body lift, dual exhaust, 31x10.5r15 BFG

Behind the brake pedal.


You know its bad when your brake lights don't work and you are 100% sure its nothing else. I.E. fuses, bulbs, wiring..

--1993 ford ranger ext cab 3.0 v6--

__________________
1993 ford ranger 3.0 v6

ok thanks for the help

__________________
96 Ranger XLT 2.3L 2wd:
camo headliner, throttle cable mod, ignition coil mod, removed sway bar, 3" body lift, dual exhaust, 31x10.5r15 BFG

Not a problem bud. Need anything else just let us know.



--1993 ford ranger ext cab 3.0 v6--

__________________
1993 ford ranger 3.0 v6

ended up being a wire that was loose under the steering column. a little connector fixed it right up

__________________
96 Ranger XLT 2.3L 2wd:
camo headliner, throttle cable mod, ignition coil mod, removed sway bar, 3" body lift, dual exhaust, 31x10.5r15 BFG

Nice. Glad you found the problem bro.