So I've installed my HIDs from DDM (9007 high/low kit). They work when my truck is turned off. As soon as I turn my truck on, the passenger side light goes out. I've triple checked everything, and my brother is going crazy right now trying to figure out what's wrong. Any suggestions? I've also sent an email to DDM support, but I figured I'd get a quicker response on here.
Thanks!

__________________
2008 XLT 4.0 auto ext cab 4x4
Levelled, 265/75/16 ProComp Xtreme AT on ProComp wheels, dual exhaust, more to come

mine does that too.. they've got to have full power (12v+) to get the ballasts powered.

i have a theory, seeing that the pass side is furthest from the battery.. its last to get the power when you start the truck up. i'm sure i'm prob wrong.

__________________
2001 Ford Ranger Supercab (4dr), Oxford White, 4.0 Sohc, 4x4, Manual trans (hurst equipped), 4:10's, 3" body lift.

I wouldn't be too concerned if it came on eventually, but it doesn't. I had to make a trip to the store and truck was running for at least 20 min and still nothing on passenger side.

__________________
2008 XLT 4.0 auto ext cab 4x4
Levelled, 265/75/16 ProComp Xtreme AT on ProComp wheels, dual exhaust, more to come

all you have to do is turn the switch off, and turn it back on again while the truck is running.

__________________
2001 Ford Ranger Supercab (4dr), Oxford White, 4.0 Sohc, 4x4, Manual trans (hurst equipped), 4:10's, 3" body lift.

Just ran out and tried that. Still no luck Thanks for the tip though

__________________
2008 XLT 4.0 auto ext cab 4x4
Levelled, 265/75/16 ProComp Xtreme AT on ProComp wheels, dual exhaust, more to come

hmm... np. check the ground lead on the pass side, the hid harness pushed my ground pin out of the stock harness and it wouldnt make a connection too.

__________________
2001 Ford Ranger Supercab (4dr), Oxford White, 4.0 Sohc, 4x4, Manual trans (hurst equipped), 4:10's, 3" body lift.

Yo edge, what kind of kits are you using? Because your display picture is sick. I like that color even in day time. Must look sick at night.

__________________
Sunny
2002 Ford Ranger Edge Flex Fuel 2wd
LED Crazy!
Complete Pioneer Audio setup
5000k HID Projector retrofit and 3000k Fogs
Achilles Desert Hawk 255/45/20 with 20'' rims
Looking for a professional retrofitter? Send me a message!

It might be because of your DRL's

__________________

98 Ranger some stuff done

PNW Crew

is this a common problem? im planning on getting the same kit soon and am just a little curious.

__________________

Ok so I don't know what my brother did but we got it working, just have to turn on my lights before starting the truck - not a big deal. But now it strobes slightly... grrr!!
I've looked into disabling my DRLs but apparently it's something the dealer needs to do as they're programmed in, not as simple as pulling a fuse anymore. I've heard of people applying their e-brake slightly to bypass them, or just turning their lights on from the start which is what I'm planning on doing. I usually turn my lights on anyways.
Any suggestions with the strobing? Still just the one side, I might have to play around with the wiring a little more...
Thanks everyone!

__________________
2008 XLT 4.0 auto ext cab 4x4
Levelled, 265/75/16 ProComp Xtreme AT on ProComp wheels, dual exhaust, more to come

If by the strobe you mean the light output kind of bouncing I used to have that. Got a relay kit and solved that problem

The kit I use has error cancelling technology built into the ballast,and comes with a relay harness, so all I had to do was wire it up, install the bulbs, and it works perfectly
55W 6000K 9007 kit

__________________
Nathan

-2010 4.0L 5-speed 4x4 Black Sport
3" SR Bodylift | T-Bar Crank | 6400 Shackles | 315/75/16 Disco S/T | Hella Rallye 4000 9" | 55W 6000K HID

drls use 6 volt.
If you ever start and realize you forget heads shut em off, push emerg a lil, then turn on and release emreg.

__________________
2006 Ranger FX4 Level 2
33x12.5 Hankook Dynamic M/T, Ion Aluminum Alloy 15x10 -4inch offset,Front winch bumper, superwinch ep9.0, 3" B/L, Torsion Crank, Chrome Bed Bar, 2 x 100 watt offroads, 6000k HID Heads/Fog(s), Pioneer H.U., 12" Jackhammer, Alpine mrp 500,train horn, whelen pa/siren
Mods
Headlight, Fog, Airbox, Blue led interior(not gauge cluster yet), blue led l/p, blue led side markers, color match skid plates
To come
sliders, suspension lift, rear bumper, tire carrier, tailgate

My HIDs go off right after I start my truck. Sometimes the left side may go off and sometimes its the right side. Seems like after a few minutes they stay on. Kinda annoying

you need a new battery or have a bad connection at the battery thats what mine did in my contour svt