There is an obvious exhaust leak on my friends 99 and my sons 02 in about the same spot. Both are 3.0 V6

There is a union between the last cat and the exhaust back, looks like it was 2 flanges, 2 screws and 2 springs. The springs are rotted along with the flanges, looks like the pipes are actually holding up but the connector is completely toast.

I know they offer a 2 piece flange for hooking the pipe to the exhaust manifold, I have used them before though never on a ranger.

I'll take a pic if I need to tomorrow but I'm hoping someone can tell by the description what I am talking about. Impossible to put a stock one on, it was on the pipe before it was welded to the cat and the exit pipe.

Thanks-

__________________
00 XLT 4WD XCSB 4.0 my new baby
00 XLT 2WD RCSB 5.0 swap in progress.
98 XLT 4WD XCSB 4.0 dead
99 EXPO donor motor for dead one and parts for the others.
Newest Ranger Forum

I cut that section out and used one of these from Autozone...
3.jpg
Works perfectly, you can weld it in or use clamps. Measure the O.D of your pipe and get one that fits. Comes in different standard sizes.

__________________
1995 Ranger XLT 3.0L OBDII
Trans: A4LD (E) 2WD
Rear: 7.5 / 3.45 NL LHD
Tires:GY P235 75/R15 (orig 225 70/R14)
Long Bed, 20 Gal Tank
Up to 229,900 miles

Here was my solution. Works great. http://imgur.com/a/gvDFC

__________________
1997 4x4 Mazda B4000 SE, Ext.Cab

What purpose are the springs? Expansion?

__________________
'04 Edge, Scab/flareside, 2wd, 3.0, 5 speed, 4:10 open. Billet grille, Raceline Raptor black wheels, 265/75/16 DuraTracs. Tbar crank, AAL. Fox shocks, Thrush welded SI/DO swept back side exit. Morimoto projectors, '06 tails and power mirrors. LEDs all the way around. Blacked out fender badge. Access Limited rollup tonneau. 5% tint on back three windows. Airbox mod, FWIW. And a Border Collie that likes it too!!

I think it's to keep tension on the bolts to keep them tight.

__________________
Myrtle: & Danna
1999 Ranger 4x4 3.0 Stepside Ext Cab XLT
2000 Mustang 4.6 Roush Supercharged ( Show Car )
1984 Elcamino 350 330 HP ( Nick's Show Car )
1959 Wife ( Arm Candy )
Danna passed away 5/26/2016

Thanks Don, thinking a bit more, that would make sense.

__________________
'04 Edge, Scab/flareside, 2wd, 3.0, 5 speed, 4:10 open. Billet grille, Raceline Raptor black wheels, 265/75/16 DuraTracs. Tbar crank, AAL. Fox shocks, Thrush welded SI/DO swept back side exit. Morimoto projectors, '06 tails and power mirrors. LEDs all the way around. Blacked out fender badge. Access Limited rollup tonneau. 5% tint on back three windows. Airbox mod, FWIW. And a Border Collie that likes it too!!

They allow flexibility in the exhaust from engine movement and retain tension.

__________________
1995 Ranger XLT 3.0L OBDII
Trans: A4LD (E) 2WD
Rear: 7.5 / 3.45 NL LHD
Tires:GY P235 75/R15 (orig 225 70/R14)
Long Bed, 20 Gal Tank
Up to 229,900 miles

Thanks Charles!

__________________
'04 Edge, Scab/flareside, 2wd, 3.0, 5 speed, 4:10 open. Billet grille, Raceline Raptor black wheels, 265/75/16 DuraTracs. Tbar crank, AAL. Fox shocks, Thrush welded SI/DO swept back side exit. Morimoto projectors, '06 tails and power mirrors. LEDs all the way around. Blacked out fender badge. Access Limited rollup tonneau. 5% tint on back three windows. Airbox mod, FWIW. And a Border Collie that likes it too!!

And thank you all, the 2 piece clamp device is what I was looking for

__________________
00 XLT 4WD XCSB 4.0 my new baby
00 XLT 2WD RCSB 5.0 swap in progress.
98 XLT 4WD XCSB 4.0 dead
99 EXPO donor motor for dead one and parts for the others.
Newest Ranger Forum