The thing is that my truck has a factory tip on it that is bigger than the exhaust piping. And I want to learn to weld so bad! So I don't know the difference between a good and bad weld ha.
Sent from my iPhone using Tapatalk
----------
Quote:
Originally Posted by bigfisher
You're gonna have to measure the tailpipe to be sure but 2.5 kinda sounds right. Measure the outside diameter (OD) and get a pipe the same size. I just straight piped my jeep and its got a 2.25" OD and I put a 2.5" OD (roughly 2.25" ID) and it slid right over and I got 2.5" clamps and clamped it. Ignore the shitty welds. I straight piped my 150 before I had my BlackWidow muffler welded in and it was my first time welding.
Sent from my iPhone using Tapatalk
|
Oh also did you see a change in low end torque like people talk about? Or does that only happen with removing the cats?
Sent from my iPhone using Tapatalk