Ford Ranger Forum - Forums for Ford Ranger enthusiasts!

Go Back   Ford Ranger Forum - Forums for Ford Ranger enthusiasts! > > >
Forgot Password? Join Us!

Welcome to Ford Ranger Forum

Closed Thread
 
Thread Tools Search this Thread

  #1  
Old 05-28-2010, 08:10 AM
STL STL is offline
...............

 
Join Date: May 2009
Posts: 23,398
Default How To: Jet Chip Install

Written By: 02'4.04x4

Discussion Thread: How To: Jet Chip Install


Tools you'll need
7/16" deep socket
10mm socket
8mm socket
Tin snips/dikes

1. Disconnect Neg. battery cable. 8mm



2. Loosen 10mm bolt on harness connector(bolt is attached to it)



3. Remove 7/16" nuts from ECU retainer plate and remove it



4. Slide out ECU



5. Snip rear access plate brace points and wiggle plate to break creased points





6. Using scotchbrite pad gently and with "care" remove film from terminals. It is not necessary or advised to remove ECU cover to clean I did it to make it clear what is being done. Take note that I am using a micro screwdriver to ensure an even pressure on the tight side. Ensure that you remove the film from 3/8" of the terminals. Look for them to have some shine to them and little to no copper should show(it means you are removing too much).




7. Blow out all dust and wipe terminals with clean dry cloth

8. Install Jet Chip on terminals





9. Carefully follow this sequence backwards to re-install.

I hope this is helpful to all any feedback on this post is appreciated.
__________________
2005 Edge

Closed Thread

Thread Tools Search this Thread
Search this Thread:

Advanced Search


Similar Threads
Thread Thread Starter Forum Replies Last Post
Discuss How To: Jet Chip Install 02'4.04x4 How-To Submissions 11 07-01-2011 06:44 PM
Jet Chip hotrodranger 3.0 Vulcan Tech 1 04-01-2010 11:30 PM
Jet chip? 94splash 4.0 SOHC / 4.0 OHV Tech 1 09-10-2009 09:32 PM
Jet Chip Anyone? 02'4.04x4 4.0 SOHC / 4.0 OHV Tech 16 09-04-2009 11:20 PM
jet chip anybody? ryangtp89 General Tech 2 06-18-2009 11:07 AM