| | Re: Clutch Pedal Position or Clutch Starter Safety Switch Replacement
Look at the new switch closely. The top of the switch will pop off allowing you to place it on the clutch rod. Hard to get your hand in the right position to do this change but I did it so you can too. Disconnect the plug to the switch and let it dangle. Pop the top off your old switch and the body of the old switch can be pulled away from the rod. Install new switch in the same order. If you look at the rod itself, you can see where it is stepped so that the switch can only work when installed properly. It is about a 5 minute job at best. Good luck.
2002 XL 5.0 with T5
Reparied or Replaced just about everything.