Yes it will work but the wiring is different just a tad
Cut the wires for your side marker light about 4-6 inches from the light-bulb housing. (a black and a brown wire) Wrap the ends that normally supply this bulb electricity with electrical tape and tuck them behind the header panel, making sure no wire is exposed to cause a short.
Cut the brown and green wire from the outer turn signal bulb as far away from the housing as possible.
Strip all the wires, for a total of 6 bare wires. (two from the side marker, 2 from the turn signal bulb-housing, and two which supply the turn signal electricity.)
Solder together all three brown wires from both lights. Secure with heat-shrink or electrical tape and ensure no wire or solder is exposed.
Solder together the two green wires with the black wire of the side marker. Secure with heat-shrink or electrical tape and ensure no wire or solder is exposed.