Need wiring help/diagram for back end of truck
Good day eeveryone.
I bought a 2008 ford ranger 2.3l 2wd last year and have an electrical problem.
There is a 16 pin harness connector between the fuel tank and frame that supplies power to the fuel pump, fuel guage, rear tail lights and possibly something else? I'm wondering if anyone can supply a wiring diagram or tell me what wires connect to what as one side had more wires then the other side. I'm guessing because a couple wires connect to each other on the back half to over ride break light with turn signal? Not sure though as I don't know much about electrical
The truck was under coated every year, but one day when I tried starting the truck there was no fuel pressure and upon pulling the plug harness apart the reason was very obvious.
A couple additional notes:
2008 ford ranger plain Jane truck
Code on harness connector: F2AB-14N003-B
Another code on harness connector: F2TB-14A464-GA
Engine side total wires(female): 15
Rear side total wires(male): 12
Last edited by Rocky87; 06-02-2019 at 08:27 AM.
|