My Vehicle:

1995 Ford Ranger Super Cab XLT 3.0L V6 2x4 RWD W/All Power Options

My Issue:

Master Window Switch will not control passenger window, it will control driver window. Passenger switch will control passenger window.

This leads me to the following conclusions:

The switch is fine (already replaced, while it was a Pick-N-Pul switch, I doubt both were broken in the same way, granted I could continuity test it).

Both motors are fine

Passenger switch is fine

So I think its an issue with the wires running from the master switch to the passenger window. But I can’t seem to find a wiring diagram for it so I can follow the wires, or where they run, etc.

Help, advice, links, vids, pics, etc are all appreciated. Thanks for the time!

- Hailey

The drivers switches go bad, just replace it


———————————
2004 ranger 4.0L edge

Its not the switch, have already tried replacing, actually my original post says i tried replacing it too

Crap read it quick... anything but switches are unusual as problems, maybe a broken wire in the rubber boots in the door jams


———————————
2004 ranger 4.0L edge

Im assuming its the wires that go to the passenger side from the master